valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
domestic fuse). Damages caused by failure to observe these installation instructions cannot be recognised. There should be a distance of at least 20 mm between the edge of the appliance and combustible walls or furniture items. The distance between the intermediate shelf and the worktop in which the range is recessed must be at least 70 mm. There should be a distance of at least 20 mm from the bottom edge of the housing trough and the next combustible item of furniture. If installed at an offset above a base cupboard or if several appliances from the Vario series are installed adjacently, the housing can lie on the side walls of the cupboard. Note: please note that a distance of 10 mm from the cupboard side walls must be observed for safety reasons. This appliance may be installed in kitchen combinations made of wood or similar combustible materials without taking additional measures. Note: do not stick the cooking surface onto the worktop with silicone! 6.2 Electrical connection VC 230-112 AC 230 V FD xxx 50/60 Hz xxxxxxxxx max. 3000 W 16 A VC 230-512 AC 240 V FD xxx 50/60 Hz xxxxxxxxx max. 3000 W 16 A Note: when installing a shelf, observe a distance of at least 20 mm from the bottom edge of the housing trough to the shelf or the next combustible item of furnishing. Rated power consumption: 3.0 kW You are advised to place a properly installed socket outlet with earthing contact around 70 cm above floor level behind the appliance. Note: if there is a need for an intermediate cupboard wall under the hob, cut out the recess so that the trough of the hob does not lie on the cupboard side wall and so that a distance of 20 mm from the intermediate cupboard wall is guaranteed. Please note that a distance of 10 mm from the base cabinet must be observed for safety reasons. (see figure) The mains connecting cable must at least correspond to type H 05 V2V2 or it must be correspondingly heat-resistant (at least 90 °C). The mains connecting cable must only be purchased through and connected by an authorised specialist. Pay attention to the information on the rating plate and connect the PE conductor. Connect the connecting cable to the mains. Connection type Y: if damaged, the mains cable must be replaced by a special mains connecting cable. The mains connecting cable must only be connected by the manufacturer or the manufacturer's after-sales service. 6.3 Installation and removal Installation – Produce the recess for one or several Vario appliance(s) in your worktop. Proceed as indicated on the installation sketch and the dimension table. The dimension table contains details of the space requirement for the trim between the appliances. Important: the angle between the cut surface and the worktop must amount to 90° (Fig. 8). – Mark the centre of the recess exactly. Secure the securing rails on the font and rear edges of the recess. Make sure that the lugs of the securing rails lie on the worktop and that the centre marking of the securing rails is precisely flush with the centre marking on the worktop (Fig. 9). – Lower the appliance into the worktop. Make sure that the engaging lugs on the appliance lie exactly on the clamping springs. Press the appliance firmly into the worktop. The engaging lugs on the appliance “snap" into the clamping springs in the securing rails (Fig. 10). Note: When installing the appliance in granite or marble worktops, have the holes produced by a specialist or stick on the securing rails with a temperature-resistant 2-component adhesive (metal on stone). ...
Questo manuale è adatto anche per i modelli :Piani di cottura - VC230112/10 (227.98 kb)
Piani di cottura - VC230212/10 (227.98 kb)
Piani di cottura - VC230512/01 (227.98 kb)
Piani di cottura - VC230512/10 (227.98 kb)