Produttore : Bosch File Size : 724.67 kb File Nome : Lingua di insegnamento:

Vai a scaricare

The hob conforms to appliance class 3 and must be installed in the worktop as shown in the installation sketch. Do not install the appliance under a suspended cupboard. For installation under a vapour extractor, a minimum clearance of 30 . . (762 mm) from the top edge of the pot stand to the bottom edge of the wall hood must be observed. If several gas appliances are installed, a larger distance from the extractor hood might be needed. Observe the installation manual of the extractor hood. Wall trims must be heat-resistant, and the minimum distance between the hob and the wall trim is at least 1 9/16 . . (40 mm). The appliance must be installed and connected by an authorised gas installer. The installation must conform with all current regulations of the gas supply companies and the regional construction regulations. Technical modifications reserved. Cabinet Requirements The minimum spaces that must be maintained when installing the gas cooktop shall be: A minimum 12 . . (300 mm) B minimum 12 . . (300 mm) C minimum 30 . . (762 mm) clearance between the top of the pot stand and the bottom of exhaust hood D minimum 1 9/16 . . (40 mm) C B A D Electrical Connection G floor8-12” (200-300 mm)24” (610 mm) max 8” (210 mm) Electrical connection (AC 110-127 V) is established by means of a connecting cable with a grounding contact plug connected to a grounded socket, which must also be accessible after installation of the gas hob. If, after installation of the gas hob, not all poles can be isolated from the power by removing the plug, an isolating device with a contact gap of at least 3 mm must be permanently installed. When establishing connections, make sure that the connecting lead cannot come into contact with hot parts of the gas hob or other hot parts. Warning: this appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug. The mains connecting cable must at least correspond to type SJT 3x18 AWG/UL/CSA or it must be correspondingly heat-resistant (at least 105 °C). The mains connecting cable must only be purchased through and connected by an authorised specialist. Gas Connection 4 9/64'' 1/2 " 1 31/32'' max. 1 7/64'' Before connecting the appliance, please check whether the local connection conditions such as gas type and gas pressure match the appliance settings. Make sure the gas supply is turned off at the manual shut-off valve before connecting the appliance. The gas connection must be in a location that permits access to the manual shut-off valve and which, if applicable, is visible after opening the door of the cabinet. SERVICER INFO ONLY Connect the gas supply using the 1/2 . . U.S.A. elbow and the fiber gasket supplied with the unit. The shorter, nontapered thread fits into the threaded nut on the hob. The longer, tapered U.S.A. thread is for the incoming gas supply. Vent the gas line, check for leaks. The gas pressure regulator is supplied with the unit and comes set for natural gas. To convert regulator to LP (propane) gas: Make-Essex Model SX 229 NA-602 1/2 PSIG 1. Remove the alumi...

Questo manuale è adatto anche per i modelli :
Piani di cottura - VG421110/02 (724.67 kb)
Piani di cottura - VG421110/03 (724.67 kb)
Piani di cottura - VG421110F/01 (724.67 kb)
Piani di cottura - VG421110F/02 (724.67 kb)

Scarica la tua

Per scaricare, digitare 2 cifre :