|
Facilità d'uso
In the instance where it is not possible to discharge cooking fumes and vapours externally even if utilising the model with chimney flue C, the cooker hood may be used in the filter version F by mounting two active carbon filters E, the fumes and vapours are then recycled via the upper grill G (depending on the model the grill may be directly placed on the chimney flue or via the mounting of two small grills - 16F). If in possession of a model with grill placed on chimney flue then two H extensions must be placed on the deflector 13F. The models provided with small dome D may only be used in the filter version F. Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. Operation The cooker hood is provided with a key or pushbutton control panel situated of the frontal part of the cooker hood, depending on the basis of the cooker hood type in possession. For proper operation= consult the text below and the relative illustration: a. ON/OFF lighting b. OFF motors c. - d. - e. Minimum suction power (c.), medium (d.), maximum (e.). f. Operation warning light (where present). Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for S minutes prior to cooking and to leave in operation during cooking and for another IS minutes approximately after terminating cooking. Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the electrical outlet. Cleaning The cooker hood should be cleaned regularly internally and externally. For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. Avoid abrasive detergents. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. Therefore we recommend oserving these instructions. Anti-grease Filter Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle. Removed from its placing by pushing the handles 0 towards the back and sliding the filter N downwards. When washed in a dish-washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. Carbon Filter (2 pieces - only for filter version) The active carbon filters E are not washable nor regenerative. It should be changed every 6 months in normal use. The active carbon filters capture unpleasant cooking odours. Apply one on each side covering both grills protecting the motor propeller, then turn the filter ...
Questo manuale è adatto anche per i modelli :Fans - BHC100K (387.17 kb)
Fans - BHC60K (387.17 kb)
Fans - BHC100 (387.17 kb)