valutazioni - 4, GPA: 4.5 ( )

Produttore : DCS File Size : 342.38 kb File Nome : Lingua di insegnamento:

Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). Fig. 3 9 Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. • Mounting - Fig. 4 Put the charcoal filter frame in place and fix it with 5 screws. Fit the charcoal filter first from the rear side and fix it frontwards using the two red keys A. • To remove proceed in the reverse order. • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. • The charcoal filter can be ordered from your local AEG Service Force Centre. Fig. 4 10 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb • Disconnect the cooker hood from the main supply. 8160 D - 8190 D • Remove the lamp cover. Fig. 5. • Replace the old bulb with a new one of the same type. • Remount the lamp cover. 8260 D - 8290 D - 8360 D - 8390 D - 8361 D - 8391 D • Press (1) the lamp cover (2) and open it. Fig. 6. • Replace the old bulb with a new one of the same type (3). • Close the lamp cover. • If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. Fig. 6 Fig. 5 What to do if If your appliance fails to work properly please carry out the followi...

Scarica la tua

Per scaricare, digitare 2 cifre :