valutazioni - 2, GPA: 4.5
(
)
)
|
Facilità d'uso
Two supplies are taken into this heater, both fan heater and storage heater circuits must be connected to the same phase of the electricity supply. IF, DURING ANY REASSEMBLY OF THE HEATER, A PART OF THE THERMAL INSULATION SHOWS DAMAGE OR DETERIORATION WHICH MAY IMPAIR SAFETY, IT SHOULD BE REPLACED BY AN IDENTICAL PART WALL FIXING: The heater must ALWAYS be mounted against, and fixed to a wall as it will not stand up by itself. A detachable bracket is provided for screwing to the wall, the heater is then placed in position and fixed to the bracket by a screw at each end. The heater must never be unscrewed or moved from the wall bracket whilst it is loaded with bricks. THE HEATER IS VERY HEAVY AND WILL BE DANGEROUS IF ITS WALL FIXING BECOMES INSECURE. Solid Brick and Concrete Walls No. 1 0 Rawlplug fibre inserts. Drill hole of 5.5mm dia to a depth in the brick of 55mm I Timber Frame Seek specialist advice, some aufhori-; ties suggest RAW'LNUT Panelled Wall, Paramount Board, Chipboard, Plasterboard, etc. Check that the panel itself is adequately fixed to battens etc. Use Rawlplug M5 intersets; drill accurate 1 0mm dia holes in single skin plasterboard. One fixing should be in studwork. Hollow concrete, Breeze Block and Thermolite Block Walls RAWLPLUG 'RAWLOK R6054R'. Some authorities suggest UNIFIX LB 70/ 10mm. Use Drill for accurate hole, not hammer or chisel. Top fixings M Controls Under Flap Front Panel Bottom Fixings Lower Front fixings Side Fixings PLEASE DON'T TAKE CHANCES Site conditions may vary considerably and Creda cannot recommend the correct wail fixings to be used, it is the responsibility of the installer to ensure that adequate permanent fixing has been achieved. Purely for guidance the suggested fixings are made for certain wall materials but this list is not comprehensive or authoritative. Different wall constructions will need different inserts. Note that inserts incorporating plastic may be subject to shrinkage behind a warm storage heater and are therefore not recommended. Wall fixings can be obtained from local stockists Support Foot CARPETS: For safety, the heater must be positioned in the room so that there is at least 75rnrri (3") free air space all around it; under windows, ensure that curtains, when drawn, cannot touch or cover the heater casing. In order to maintain stability, it is essential that the heater be placed on a level surface and care should be taken to avoid irregular surfaces, such as may result from carpets or tiled surrounds partially protruding under the heater. The heater feet are designed to go underneath a carpet rather than standing on it; this permits the weight to be taken on a firm base. Carpet gripper should be removed from behind the heater feet. BRICKS: The heater casing and the heater storage bricks with which it must be fitted, are delivered in separate packages. The brick is common to ail heaters, packed in pairs. The brick catalogue number is 791 40201 5. 7934 and 75772...
Questo manuale è adatto anche per i modelli :Fans - 75772001S (635.77 kb)
Fans - 75772003S (635.77 kb)
Fans - 793485 (635.77 kb)
Fans - 793585 (635.77 kb)