valutazioni - 2, GPA: 3.5
(
)
)
|
Facilità d'uso
AEG - putting words into action. View of the Hood 1) Extendable Vapour Guide 2) Filter Grille 3) Lighting 4) Motor Switch 5) Light Switch 1 5—arD*. ш. General Extraction mode The cooker hood can be used : either as an exhaust air appliance (extraction mode) or as a return air appliance (recirculation mode) via a carbon filter (optional extra). Preparation for installation In this mode the fumes are extracted to the outside via a venting hose connected to the coupling ring A, placed in hole B (fig. 1). Depending on your installation the hose can be directed either towards the ceiling or towards the walls(fig. 2). In the extraction mode the outlet venting hose should to be 120mm in diameter, but 100mm or 110mm venting hoses can be used by inserting the multiconnector flange (fig. 1), supplied with the hood on the coupling ring A, before connecting the hood to the outlet venting hose. If the venting hose runs horizontal it must be slightly slanted upwards (about 10°) to ensure the air is vented easily from the kitchen to the outside. If the hood is to vent out into the open air through an external wall, you need a telescopic wall box (optional extra). Wall box and venting hoses are available via your AEG Stockist or AEG Spare Parts. Flame retardant venting hose is available in 120 and 100mm diameter. Other flame retardant materials such as KA piping can be used. Optimum operation of the cooker hood in the extraction mode is assured only if the following points afe observed: - short, straight exhaust air runs - as few hose bends as possible - running of the hose in smooth flat arcs not at sharp angles. - as large as possible hose diameter Failure to observe these principles will result in serious power losses and increased operating noise. 8 In this mode the fumes filter through an active carbon filter (optional extra) and are returned into the room. To fit the carbon filter remove the grille C by turning locks D and pull it out downwards (fig. 3). Fit the filter in the seat at the front and fasten it at the back with the two hooks E (fig. 4). The cover F (fig. 5) must be fitted over the hole B (fig. 1) fixing it with the special screw provided. This cover deflects the air forwards avoiding soilage of the rear wall. Important: In the extraction mode the exhaust air must not be introduced into a smoke flue or exhaust gas chimney.lntroduction of the exhaust air into a shaft used for ventilation of the installation spaces of firerooms is not permitted. If the exhaust air is introduced into a operational smoke flue or exhaust gas chimney, it is advisable to seek the advice of a competent chimney-sweep. The official exhaust air guidance regulations are to be complied with. During operation in the extraction mode, an adequate air opening of approximately the same size as the exhaust air opening should be ensured. According to the Provincial Building Regulations, the joint operation of fume extractor hoods and chimney-linke...
Questo manuale è adatto anche per i modelli :Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)