Log:
valutazioni - 1, GPA: 3 ( )

Istruzioni per l'uso CFM, Modello Cooker Hood 3LI0D3UL

Produttore : CFM
File Size : 158.04 kb
File Nome : e0d1f07b-8885-40bc-a6d6-0dfc2df1e718.pdf
Lingua di insegnamento: enfr
Vai a scaricare



Facilità d'uso


DECOR MODEL INSTALLATION INSTRUCTIONS AND OPERATING INSTRUCTION READ AND SAVE THESE INSTRUCTIONS 1. GENERAL 1.1 Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations. The appliance has been designed external exhaust version cooker hood. 2. INSTALLATION INSTRUCTIONS 2.1 Power Supply Connection For connection to the power supply refer to the follows: BLACK = L line WHITE = N neutral GREEN / YELLOW = G ground A double-pole switch properly rated must be installed to provide the range hood power supply disconnection. 2.2 The appliance must be installed at a minimum height of 26 inches (66 cm) from an electric cooker stove, or 30 inches (76 cm) from gas or combined cooker stoves. If a connection ductwork composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the range hood exhaust duct air to the same duct air used to exhaust hot air or fumes from other appliances other than electrical. 2.3 Mounting the cooker hood to the wall. Drill holes A-B-C-D according to indications quoted in (fig. 3). Use screws and screw anchors suitable for wall (e.g. reinforced cement, plasterboard) for the mounting of the cooker hood. Where screws and screw anchors are supplied ensure that they are suitable for the type of wall where the cooker hood is to be mounted. Lock in the flange connector Y to the cooker hood (fig. 2) with the supplied screws. Affix the bracket Z to the wall via the drill holes A (fig. 4) . Hang the cooker hood on the wall using the drill holes C (fig. 3). Fasten the cooker hood using the fastening drill holes D (fig. 3). 2.4 Extracting version Connect the flange Y to the discharge opening with a connecting tube. Thread the upper connector E to the inside of the lower connector F; hang the two connectors inserting them vertically on the cooker hood locking the lower connector F to the wall using the drill holes B (fig. 3), unthread the upper connector E towards the top, locking it in with the supplied screws in the drill holes G of the bracket Z (fig. 2) previously affixed to the wall via the drill holes A (fig. 3). 3. USE 3.1. If the apparatus is equipped with the following controls (fig.5): A) LIGHT B) OFF C) SPEED I D) SPEED II E) SPEED III F) AUTOMATIC STOP TIMER - 15 minutes The “automatic stop timer” delays stopping of the hood, which will continue functioning for 15 minutes at the operating speed set at the time this function is activated. 3.2 If the apparatus is equipped with the following controls (fig.6): A) OFF B) SPEED I C) SPEED II D) SPEED III E) LIGHT 4. MAINTENANCE 4.1 It is recommended to operate the appliance prior to cooking. It is recommended to leave the appliance in operation for 15 minutes after cooking is terminated in order to completely eliminate cooking vapours and odours. The proper function of the cooker hood is conditioned by the regularity of the maintenance operations. 4.2 The anti-grease filters capture the grease particles suspended in the air, and are therefore subject to clogging according to the frequency of the use of the appliance. In order to prevent fire hazard, it is recommendable to clean the filter at a maximum of 2 months by carrying out the following instructions: -Remove the filters from the cooker hood and wash them in a solution of water and neutral liquid detergent, leaving to soak. - Rinse thoroughly with warm water and leave to dry. -The filters may also be washed in the dishwasher. The aluminium panels may alter in colour after several washes. This is not cause for customer complaint nor replacement of panels. 4.3 Clean the fan and other surfaces of the cooker hood regularly using a cloth moistened with denatured alcohol or non abrasive liquid detergent. 5. FUSE 5.1 The halogen lamps circuit is controlled by a fuse 5x20 mm , 125 V 5A . In case of necessity it can be replaced only by specialized personnel. INSTRUCTIONS DE SECURITE IMPORTANTES LIRE ET CONSERVER CES INSTRUCTIONS. VEUILLEZ LIRE TOUTES LES INSTRUCTIONS AVANT DE PROCEDER. IMPORTANT: Conserver ces instructions pour les Inspecteurs Ele...

Questo manuale è adatto anche per i modelli :
Fans - Cooker Hood 3LI0D3UL (158.04 kb)

Scrivi la tua opinione del dispositivo



Il messaggio
Il tuo nome :
Inserire le due cifre :
capcha





categorie