We recommend that you keep all merchandise with hard tags a minimum of 4-1/2 feet from the sides of the system and 3 feet from the front of and back of the system. This will reduce the possibility of the system being alarmed by the displayed merchandise. Text Box: 9 Text Box: DETECTION AREA Text Box: 10 Text Box: There are three reasons for the system to alarm: 1. The REAL alarm: The occurrence of a shoplifting attempt. 2. The ACCIDENTAL alarm: a) Personnel neglected to remove a tag at the point

9. Plug the power supply into the closest outlet. We do not recommend using an extension cord for the system. 10. Test the system by placing one of the hard tags into the system. The system will beep approximately 1-1/2 seconds then reset. If a hard tag is held in the system it will continue to alarm. Text Box: 4 Text Box: 1. The tag should be visible to the customer. 2. Tag uniformly, it speeds up removal. 3. Tag near a price label. It assists in the removal. 4. Place the tag as high as possibl

3 Tagging Guidelines …………………4 Removing Hard Tag……………….. 7 Detection Area ……………………... 9 Alarm Handling …………………….. 10 Troubleshooting ……………………. 11 Warranty…………………………….. Back Cover Text Box: SP-1 USERS GUIDE INDEX Text Box: 5’ RUBBER MOLDING & DOUBLE SIDED TAPE Text Box: 1 Text Box: POWER SUPPLY WITH 10’ OF CORD Text Box: CAP NUTS AND WASHERS Text Box: BASEPLATE Text Box: SP-1 ANTENNA WITH WIRE Text Box: Remove all contents from packaging. Compare products with the example. If you are missing any

Remove the pin and hard tag from the detacher and store for future use. Text Box: 2. Remove the pin by holding the hard tag to the detacher and pulling straight up on the pin or garment. Text Box: 1. Place the hard tag into the detacher with the pin facing up. Text Box: REMOVING HARD TAG Text Box: 8 Text Box: THIS SPACE INTENTIONALLY LEFT BLANK Text Box: It is possible for the locking mechanism to become jammed when the pin is pulled extremely hard. It is possible to un-jam the pin so that you w

Locate the baseplate, cap nuts and washers. 2. Place the antenna on top of the baseplate, aligning the holes in the antenna base with the studs on the baseplate. Make sure that the power supply wire is in the channels of the antenna base and is not crushed between the antenna base and the baseplate. 3. Attach the washers and cap nuts to the bolts on the baseplate. DO NOT TIGHTEN. 4. Again make sure that the power wire is not crushed between the antenna base and baseplate and tighten the cap nuts