valutazioni - 4, GPA: 4.3 ( )

Produttore : Haier File Size : 189.25 kb File Nome : Lingua di insegnamento:

• Securing the bracket 1. Recommend you to secure the legs of the water heater on a foundation with embedded irons. You can also make cement bricks, attach expansion bolts in the cements and fix the heater legs on the expansion bolts. 2. Adjust the height of the bracket using the hard, waterproof spacers to ensure levelness of the water tank as well as even the load of each leg. Notes: 1. Ensure close contact of all legs of the water heater with the support plane. No legs are allowed to hang in the air as this may cause deformation of the bracket and thus damage the water heater. 2. In the areas where typhoon happens frequently, fix the water tank and bracket firmly on the roof with wire rope. 3. The water heater must be installed stably and firmly. Otherwise serious damage or injury may occur in bad weather. • Installing the water tank 1. Take the water tank from the packing case and remove the nuts and shims attached to the bolts on both sides of the tank. 2. Insert the bolts on the bottom of the tank into the long holes in the tank support of the bracket and attach the shims and nuts. Notes: 1. To reduce scratching, remove the protective plastic film from the water tank after the installation is finished. Never use sharp tools such as wallpaper knives to remove the film. 2. The assembly of the water tank is realized by bolt connection and nut fixing. Tighten all nuts after the assembly of whole water heater is finished. 3. When installing the water tank, please keep the center lines of the connection holes of the vacuum tubes parallel with the oblique-pulling posts of the bracket. Installation instructions • Installing the vacuum tubes 1. Before installing, the vacuum tubes should be protected from sunshine. Otherwise you may be burned during installation. 2. Put the wind shroud on a vacuum tube (Fig. A). 3. Insert the vacuum tube with even force while rotating to turn it into the seal rings. The direction of the resultant force should be consistent with the axis of the vacuum tube. 4. Put the tail-holder into the tailstock (Fig. B) and then fasten the vacuum tube on the tail-holder (Fig. C). 5. The insertion depth of the vacuum tube into the seal ring should be about 1cm. Push the wind shroud onto the water tank to plug the joint (Fig. D). 6. When installing the vacuum tubes, one tube should be installed on each side of the water tank first so that the water tank and bracket can be positioned as a whole. Notes 1. Check if the seal rings in the tank holes are all ready, if the sealing planes are clean, free of foreign bodies and breakage. 2. Put the wind shroud on the open end of the vacuum tube with the inclined plane downward and to a position about 10cm to the tube end. Before installing, wet the tube end with water to facilitate installation. A Seal ring Vacuum Wind B Vacuum Tail-holder Tailstock Tailstock Wind shroud Corking up position Tail-holder C D Installation instructions • Schematic drawing of the indoor pipeline and wiring Solar w...

Scarica la tua

Per scaricare, digitare 2 cifre :