valutazioni - 2, GPA: 4.5 ( )

Produttore : Bosch File Size : 1.53 mb File Nome : Lingua di insegnamento:

Customer Service Troubleshooting Tips Care and Cleaning Operating Instructions Installation Instructions Safety Instructions Water Temperature Setting… Maximum water temperatures occur just after the burner has shut off. To determine the water temperature, turn on a hot water faucet and place a thermometer in the water stream. The wide reference mark near WARM on the rim of the temperature dial, represents an approximate water temperature of 120°F. The long wide reference mark, to the left, represents an approximate water temperature of 130°F. Each reference mark above or below these points indicates an approximate change of 10°F. To adjust the temperature, turn the temperature dial to an initial setting of 120°F. Therefore, always remember to test the water temperature with your hand before use and remember that hotter water increases the risk of scald injury. Also, always supervise young children or others who are incapacitated. The gas control (thermostat) is constructed with a built in safety shut-off device designed to shut off the gas supply to the burner if the pilot flame is extinguished for any reason. The gas control (thermostat) is also equipped with a single use gas shut off device that will shut off the gas supply to the burner if the water heater exceeds normal operating temperatures. Refer to the BEFORE YOU CALL FOR SERVICE section of this manual, or contact your dealer. A condition known as “stacking” or “layering” can occur when a series of short and frequent hot water draws are taken. The hottest temperature water will be at the top of the tank, closest to the outlet pipe delivering hot water to the home. Stacking can cause this top layer of water ! WARNING: Should overheating occur or the gas supply fail to shut off, turn off the manual gas control valve to the appliance. If the water heater has been subjected to fire, flood or physical damage, turn off the manual gas control (shut-off) valve, and do not operate the water heater again until it has been checked by qualified to be hotter than the water toward the bottom of the tank near the gas control personnel. (thermostat). NOTICE: Replace any part of the gas control system which has been under water. Red Button Temperature dial (Temperatures are approximate) WARM VACATION HOTCAUTION TWATEINCRHERISK OFSCALDINJURY R EASSEHOTTER W A RNING READ ALL INSTRUCTIONS BEFORE LIGHTING Gas cock knob 120°F 130°F 110°F 100°F 140°F 150°F 160°F 90°F 80°F 70°F 60°F 18 Care and cleaning of the water heater. Safety Instructions Installation Instructions Operating Instructions Care and Cleaning Troubleshooting Customer Service Draining the Water Heater ! CAUTION: Shut off gas to the water heater at the gas control (thermostat) gas cock or manual shut-off valve before draining water. ! DANGER: Before manually operating the temperature and pressure relief valve, make certain no one will be exposed to the hot water released by the valve. The water drained from the tank may be hot enough to present a scald hazard and should be directed to a suitable drain to prevent injury or damage. In order to drain the water heater, turn off the cold water supply. Open a hot water faucet or lift the handle on the relief valve to admit air to the tank. Attach a garden hose to the drain valve on the water heater and direct the stream of water to a drain. Open the valve. ! DANGER: Before manually operating the relief valve, make certain no one will be exposed to the danger of the hot water released by the valve. The water may be hot enough to create a scald hazard. The water should be released into a suitable drain to prevent injury or property damage. ! DANGER: Hotter water increases the potential for Hot Water Scalds. ! DANGER: Failure to perform the recommended Routine Preventative Maintenance can harm the proper operation of this water heater, which can cause carbon monoxide dangers, excessive hot water temperatures and other potentially hazardous conditions Routine Preventative Maintenance Properly maintained, your water heater will Because accumulated solids can prevent the provide years of dependable trouble-free gas control (thermostat) sensors from service. accurately reading the water temperature, It is recommended that a periodic inspection the water at the fixture can be hotter than of the gas control (thermostat), burner, the gas control (thermostat) dial setting. It relief valve, internal flue-way and venting is suggested that a few quarts of water be system should be made by service personnel drained from the water heater’s tank every qualified in gas appliance repair. month to clean the tank of these deposits. It is suggested that a routine preventative Rapid closing of faucets or solenoid valves in maintenance program be established and automatic water using appliances can cause followed by the user. a banging noise heard in a water pipe. At least once a year, lift and release the Strategically located risers in the water pipe lever handle on the temperature pr...

Scarica la tua

Per scaricare, digitare 2 cifre :