valutazioni - 3, GPA: 4.3
(
)
)
|
Facilità d'uso
. . . . . . . . . . . . . . . . . . . . . . . . . . . .3 II) Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 III) Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 IV) Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 V) Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 PLEASE RETAIN THESE INSTRUCTIONS IN A SAFE LOCATION FOR FUTURE REFERENCE WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency or the electric utility. FOR YOUR SAFETY • Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. • Installation and service must be performed by a qualified installer, service agency or the electric utility. WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. GSW Water Heating is a division of GSW Water Products Inc. PART NO. 71800 REV. B (06-07) INSTALLATION RECORD Record key data here for future reference and prompt service: Installed By / Purchased From Installation Date Location of Electrical Switch or Circuit Protector Model Number Serial Number Circulator Pump Type Boiler/Water Heater BTU Input Volts P.S.I. U.S. Gal. - 2 I) INTRODUCTION III) INSTALLATION I) INTRODUCTION III) INSTALLATION Thank you for purchasing this FlowThru® storage tank. Properly installed and maintained, it will provide years of trouble free service. The warranty on this storage tank is in effect only when the tank is installed and operated in accordance with these instructions. The manufacturer of this tank will not be liable for any injury or property damage resulting from failure to comply with these instructions. IMPORTANT: Read and understand these instructions before installing and operating your storage tank. Description The FlowThru® series of storage tanks have been designed to supply hot water for domestic use when combined with a tankless coil boiler or instantaneous water heater (IWH). Each tank is equipped with an adjustable thermostat, pre- wired and ready for connection to a circulator pump (not supplied). These tanks are not constructed to ASME requirements and should not be used for such applications. The FlowThru® series of storage tanks has been optimized to maximize hot water flow rate capabilities of an instantaneous water heater or tankless coil boiler. They provide a faster recovery than regular electric or gas-fired tank type water heaters of the same storage capacity. Always use a mixing valve on the hot water outlet (not provided). II) SAFETY Relief Valve Requirements For protection against excessive temperatures and pressure, install temperature and pressure protective equipment required by local codes, but no less than a combination Temperature and Pressure (T&P) Relief Valve certified as meeting the requirements for “Standard For Relief Valves For Hot Water Supply Systems, ANSI Z21.22/CSA 4.4”. The valve shall be marked with a maximum set pressure not to exceed the maximum working pressure of the storage tank. The T&P valve shall be rated for the BTU INPUT of the entire system. This T&P valve may be in addition to any T&P valve that is required on the boiler or instantaneous water heater system. Install the valve into the opening provided on the storage tank, or other approved system location. Provide tubing so that any discharge from the valve will exit within 152mm (6 in.) above, or any distance below the structural floor and cannot contact any live electrical part. The end of the relief pipe opening should terminate near the floor drain or other suitable location. Do not place a valve(s) or any other blockage or restrictions between the tank and the T&P valve. WARNING Excessive Weight Hazard Use two or more people to move and install storage tank. Failure to do so can result in back or other injury. Local Codes The installation of this storage tank must be In accordance with these Instructions and all applicable local codes. Location Locate the storage tank in a clean dry area close to the water-heating source and preferably central to the piping system. Adequate clearance for accessibility to permit maintenance and service must be provided. Water lines and the storage tank should be protected from freezing temperatures. Do not install the storage tank in outdoor unprotected areas. It is necessary to have a floor drain nearby to permit easy draining (see Figure 1). IMPORTANT This storage tank must be installed strictly in accordance with the instructions enclosed, and local electrical, fuel and building codes. It is possible that connections to the tank, or the tank itself, may develop leaks. IT IS THEREFORE ...
Questo manuale è adatto anche per i modelli :scaldabagno - FlowThru (390.01 kb)