Log:
valutazioni - 2, GPA: 3 ( )

Istruzioni per l'uso Danby, Modello DDR556RH

Produttore : Danby
File Size : 269.21 kb
File Nome : 06f39c07-c065-4e15-8fcd-983ecb97a3b2.pdf
Lingua di insegnamento: enfr
Vai a scaricare



Facilità d'uso


10 FAN ONLY MODE SELECTION: 1. Press the MODE button until the fan blade symbol is shown in the mode area of the display. 2. Press the "Fan” symbol on the keypad. Each time the button is pressed, the mode selection will alternate between "High Fan" and "Low Fan" speed options. 3. When all settings are complete, press the on/off button to start fan mode operation and the blue operation light will illuminate. AIR FILTER: Your dehumidifier features a removable Air Filter. This filter is located at the front of the unit (behind the front air intake grill) The air filter plays an important role in helping to reduce (minimize) dust/dirt particles from the surrounding environment. A blocked/clogged air filter reduces air flow impacting negatively on operating efficiency. To maintain maximum operating efficiency; The filter must be checked and cleaned regularly. (every 2 weeks) More frequent cleaning may be required depending upon indoor air quality. IMPORTANT: Never operate the unit without the air filter in place. AIR FILTER REMOVAL: 1. Locate the air filter (handle) tab on the upper right side of the front air intake grill and slide-out the filter to the right. 2. Clean the filter thoroughly using a vacuum cleaner or wash using luke warm water and mild detergent. Dry thoroughly before re-installing. 3. To re-install the air filter, slide the filter back inside the tracks until it snaps (locks) into position. Direct Drain Feature (Dehumidifier Mode ONLY): This appliance is inclusive of a direct drain feature, located at the lower (left) rear side of the cabinet. NOTE: The drain hose and coupler are included with this unit. The direct drain feature is intended for use in basements inclusive of a floor drain only. NOTE: Do not attempt to operate the direct drain feature using drain/stem pipes above ground level. Fig.3 (Rear View) DIRECT DRAIN CONNECTING THE DIRECT DRAIN: 1. Unscrew the drain cap on the direct drain connection. at the back of the unit. 2. Cut drain hose to required length. (to suit your needs) Attach drain hose coupler directly onto the direct drain and tighten. 3. Position the open end of the drain hose directly over the floor drain and start the unit. 4. Position the dehumidifier as close as you can to the floor drain. 5. When the direct drain feature is not being used, remove the drain hose and re-install cap. Care and Maintenance AVERTISSEMENT – AVIS IMPORTANTS CAUTION: Before attempting to clean and/or service this unit, always disconnect the power supply cord from the electrical power supply/outlet. 1. DO NOT use gasoline, benzene, paint thinner, or any other chemicals to clean this unit, as these substances will damage/deform both plastic components and luster finish. 2. Never attempt to clean the unit by pouring water directly over any of the surface areas, as this will cause deterioration of electrical components and wiring insulation. 3. Use only a mild dishwashing detergent, lukewarm water and a soft cloth to wipe the exterior surface of the unit and dry throughly. Storage When the appliance is not being used for long time periods, please follow these instructions. 1. Disconnect the power cord from the power supply. 2. Empty the water tank and wipe (clean) thoroughly. 3. Clean air filter thoroughly 4. Re-package the unit in the original carton. 5. Store the unit upright in a dry location. NOTE : Les instructions de securite et AVERTISSEMENTS presentes dans ce manuel ne couvrent pas toutes les conditions possibles et situations qui pourraient se produire. Tous et chacun doivent comprendre que le bon sens et la prudence sont des facteurs qui ne peuvent etre incorpores dans l’appareil lui-meme. Ceux-ci relevent uniquement du comportement de la personne qui installe ou utilise l’appareil, ou qui en fait l’entretien. Le defaut d’observer les directives de l’installation, de l'utilisation ou de l'entretien de l’appareil fournies par le fabricant pourrait causer des blessures corporelles et/ou des dommages materiels. L’utilisateur devrait communiquer avec le detaillant ou un agent de service d’apres-vente du fabricant au sujet de tout probleme ou situation qui n’est pas parfaitement compris. (Pour le Service a la Clientele Danby, composez le 1-80026- DANBY / (1-800-263-2629) POUR LA SECURITE DES UTILISATEURS – Pour minimiser tout risque d’incendie ou d’explosion, ne jamais remiser d’essence ou autres produits liquides ou gazeux inflammables a proximite de cet appareil ou de tout autre appareil menager. CIRCUIT ELECTRIQUE – Pour reduire le risque d’incendie, de choc electrique ou de dommages corporels, on doit s’assurer que tout cablage electrique et circuit de mise a la terre soient conformes aux codes national et local de l’electricite. C’est a l’acquereur qu’incombe la responsabilite de consulter eventuellement un electricien qualifie qui pourra inspecter le cablage et les fusibles de la residence et determiner si la source d’electricite disponible est adequate pour l’alimentation de l’apparei...


Scrivi la tua opinione del dispositivo



Il messaggio
Il tuo nome :
Inserire le due cifre :
capcha





categorie