valutazioni - 3, GPA: 4.3 ( )

Produttore : Americair File Size : 86.43 kb File Nome : Lingua di insegnamento:

OPERATING INSRUCTIONS With proper care and maintenance, you will enjoy many years of service and dramatically improve the quality of your indoor air. The AMAIRCARE HEPA Air Filtration System is designed to operate continuously and the unit should be left in operation at all times. INSTRUCTIONS 1. The unit may be operated in a wide variety of situations. Contact your HVAC contractor for specific instructions. 2. Plug the unit into a grounded outlet (120 Volt, 60 Hz or 230 Volt 50/60 Hz). 3. Turn the unit on by rotating the control dial clockwise until you hear or feel it click (Some 4000V and 5000V models only have an on off switch). 4. The unit will come on in the “HIGH” position. To Reduce the air flow, continue to rotate the control dial clockwise. 5. To turn the unit off, rotate the dial counter-clockwise past the “HIGH” position until you hear or feel it click. CAUTION! 1. Make sure that the line cord is not in the path of people walking or where anything can be rolled over it. 2. The unit should be leveled after installation by adjusting the leveler feet. 3. Locate the unit such that there is no possibility of moisture dripping on it. Moisture could leak into the unit and damage the filter or electrical components. 4. The Air Filtration System discharges clean air through the duct connection on the top of the unit at the back. 5. Before removing the door of the blower/motor section, disconnect the power cord. NOTE: You may notice a slight “new” smell from the Air Filtration System when you first turn it on. This is normal and harmless and it will dissipate within a few days. FILTER REPLACEMENT INSTRUCTIONS The AMAIRCARE HEPA Air Filtration System is designed to run continuously. To ensure optimal performance, please carefully follow the Product Information and Owner’s Manual Instructions. FILTER REPLACEMENT INSTRUCIONS: 1. Read these instructions completely. 2. Unplug your unit from the power supply outlet. 3. Open the front door of the unit to gain access to the filter compartment. 4. Lift the rod that holds the filter in place and remove the metal plate covering the end of the filter. 5. Remove the HEPA cartridges from the unit. NOTE: The carbon pre-filter and the HEPA filter will contain contaminants. Remove them slowly from the unit in order to avoid dusting. 6. To change the first-stage carbon filter, peel off the black pre-filter that surrounds the HEPA cartridge and discard into a plastic waste bag. 7. Wrap the new pre-filter around the HEPA cartridge completely enclosing it with the carbon blanket. Then peel off the paper backing of the adhesive strip on the inside of the pre-filter and overlay the adhesive strip on the filter to seal it tightly. The inner blanket (third stage filter) can be changed similarly however there is no adhesive strip needed to hold it in place. 8. Replace the HEPA cartridge complete with the new pre-filter and inner blanket (if changed) into the casing, making sure it is seated in the ring at the back of th...

Scarica la tua

Per scaricare, digitare 2 cifre :