valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
Self Cleaning 220-240V..50Hz 150 2.12 14.5±1 .300(max.) .69 20 900 460 600 70 Product Introduction Overheated fat or oil is highly inflammable. Only prepare food cooked in fat or oil when cooking can be fully supervised. Under no circumstances attempt to extinguish burning fat or oil with water. Choke the fire using a lid or fire blanket. Before using for the first time: Make sure the light bulb, grease filter frame, and oil collector of the cooker hood have already been correctly installed. In Use: Accumulated oil and grease in the filter and oil collector increases the risk of fire and influences the efficiency of the cooker hood. Adults and children must not operate the appliance without supervision, if they are physically or mentally incapable of doing so, or if they lack the knowledge and experience required to operate the appliance correctly and safely. Light bulbs must always be fitted before the cooker hood is in use. Defective bulbs should be replaced immediately to prevent the remaining bulbs from overloading. NEVER insert or remove an electric plug with wet hands. DO NOT drag the wire to remove the electric plug. After Use: If the cooker hood is not used for a long time, please remove the electric plug from power supply for safety. Operating Instruction Getting Familiar with Your New Cooker Hood LC38S953.. 1 3 4 65 7 82 1. Duct 2. Screen 3. Inner frame 4. Filter frame 5. Oil collector 6. Front panel 7. Lamp 8. Switch Control Panel 1 3 4 5 62 This appliance uses advanced touch control. The surface is easy to clean up and it has a long life time. 1. “Fan Power ” button To turn on and off the fan power. 2. “Light ” button To turn on and off the lamp. It can be controlled individually, without influence of other buttons. 3. The four button “ ” To set time, alarm, self cleaning, ventilation, and lock function. 4. “Fan Speed ” button To control the fan speed. 5. “Time-delay ” button To set delay time to turn off the fan power. 6. “ Gas hob > Cooker hood” Interlink function The cooker hood can be connected with applicable hob. (this symbol has no operating function). The operation of applicable hobs please follow the Operating and Installation Manual for applicable hob. Operating Instruction 1. Every time the power is reconnect ,the clock shows Operation Explain 88:88 and flash. Only after adjust the clock and press “ok/esc” , the flashing shops. All other function can use at all time. 2. Set clock: press “ ” till “ ” flash. And press “ok/esc” enter setting clock status. The hour will flash, press“+/-” to adjust the hour. Press “ok/esc” again. The minutes will flash, press “+/-” to adjust the minutes. After adjust the right value, press “ok/esc” finish setting clock. Normally display the clock. When go into the set the process of “+/- ok/esc” for more than 1 minutes, the setting could be automatically retreat and the program change to normal mode . Normal display clock 3. Turn on the fan: first press switch button “ ” fan start the 3rd speed, the window display“ ”, can be adjusted. Press fan speed button“ ”the speed can be adjusted and show the fan symbol. Press switch button“ ”again, the fan will be turn off. 4. Lamp control: Press lamp button“ ”, the lamp turn on, press again, the lamp turn off. 5. Delay function: when hood working, press delay button “ ”,window right top corner show “ 03 ”,press “+/-” adjust the delay time, max 15 Minutes. If the time arrives, the display and motor turn off automatically. 6. If set to “0”, and no adjust in 3 seconds, it will exit the delay function, the fan will keep running. If press the switch button“ ”before delay time arrive, the fan will turn off directly. 7. Set clock, alarm, ventilation and function: First press “ ” button, show symbol “ ” and flash. Press “ ” again, 4 symbol “ ” flash circularly. When anyone symbol flashing, press “ok/esc” button. Enter relevant function. Set clock please reference 2nd . Set alarm function: press “ ” till symbol “ ” flash, press“ok/esc” display residual time, re-press “ok/esc” in 5 second, enter setting alarm function. The minutes, flash, press“+ -” adjust to right hour. Press “+ -” adjust to right hour. Press “ok/esc” finish the alarm setting, exit to the clock display, startup the alarm function and show “ ” till alarm finish , the buzzer will remind. Operating Instruction If in the setting status, in 1 minute no press “+ -ok/esc” will exit alarm to “00:00” or press”ok/esc” keep in 3s in setting status, can cancel the alarm function. Self cleaning function: When the hood is used for a certain time, the self cleaning function icon on the display will flash. It indicates the self cleaning function should be activated. Any other functions except light and linkage function should be closed, then press the “ok/esc” button to start the self-cleaning function. As the down-counter is shown on right-up corner of the display. The self cleaning function will keep running for about 30 minutes. When finished, the display will automatica...