|
Facilità d'uso
RISK OF INJURY Do not allow children to play with the extractor hood! Adults and children must never operate the appliance unsupervised – if they are not physically or mentally capable of doing so, – or if they do not have the knowledge and experience to operate the appliance correctly and safely. Technical safety • The extractor hood left the factory in perfect condition. Nevertheless check the appliance for visible damage before installation. If it is damaged, do not switch it on! • If the power cord of the extractor hood is damaged, it must be replaced by the manufacturer, his customer service or a similarly qualified person to prevent hazardous situations. • Only a qualified technician may install (including electrical connection), service or repair the extractor hood. Always isolate the extractor hood by pulling out the mains plug or switching off the fuse! • If the appliance is improperly installed, serviced or repaired, the user may be placed in considerable danger for which the manufacturer is not liable. • Changes to the electrical or mechanical installation are dangerous and must not be undertaken! They may also cause the extractor hood to malfunction. Simultaneous operation of the extractor hood with a heating appliance which is dependent on ambient air • Heating appliances which are dependent on ambient air, e.g. gas, oil, wood, or solid-fuel heaters, instantaneous water heaters, hot water boilers, hobs or ovens, and which draw combustion air out of the installation room and whose exhaust gases are conveyed to the exterior by a flue. RISK OF POISONING If the extractor hood is operated at the same time as a heating appliance which is dependent on ambient air, there is a risk of poisoning due to combustion gases being drawn back in. Safety instructions • Safe operation is possible provided the low pressure in the installation room of the heating appliance does not exceed 4Pa (0.04mbar). This can be achieved if the combustion air can flow through non-closable openings, e.g.in doors, windows, in conjunction with air intake/exhaust air wall boxes or by other technical measures. • Adequate intake air must therefore always be provided. • An intake/exhaust air wall box alone does not ensure compliance with the limit value. NOTE:When making your evaluation, always consider the entire ventilation system in the home. Include the advice of a competent heating engineer when making your evaluation. • If the extractor hood is used in circulating air mode only, it can be operated without any restrictions. Special information for gas cookers • When installing the extractor hood above gas hobs, observe the appropriate national statutory regulations (e.g. in Germany: Technische Regeln Gasinstallation TRGI). • Observe the currently valid installation regulations and instructions of the gas appliance manufacturer. • During installation, ensure that only one side of the extractor hood is situated directly next to a high-sided unit or a wall. Otherwise, there is a risk of heat build-up. The gap between the extractor hood and the wall or high-sided unit must be at least 50 mm. RISK OF BURNS Do not operate more than 2 gas cooking areas simultaneously over a period of max. 15 minutes at maximum thermal load. Due to the effect of the heat there is a risk of burns if the surfaces of the housing are touched! • Note that one large burner of more than 5 kW (Wok) is equivalent to the power of 2 gas burners. • The extractor hood may be damaged by the intense heat. • Never operate a gas cooking area without a cooking utensil on it. Regulate the flame in such a way that it does not project over the cooking utensil. Safety instructions Proper use • Clean the extractor hood thoroughly before using for the first time. • Before cleaning and servicing the extractor hood, isolate it from the power supply by pulling out the mains plug or switching off the fuse. • Bulbs (especially halogen bulbs) become very hot during operation. Even some time after th...
Questo manuale è adatto anche per i modelli :Cappe - LC657BA20/01 (2.21 mb)
Cappe - LC754BB20/01 (2.21 mb)
Cappe - LC954BB20/01 (2.21 mb)
Cappe - LC957BA20/01 (2.21 mb)