valutazioni - 2, GPA: 5
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
10 11 24 REATTACHING THE REFRIGERATOR DOORS Reattaching the Refrigerator Door 1) Insert the lower hinge (.) in the bracket 2) Place the hole in the refrigerator door (.) lower hinge (.). over the lower hinge (.). 3) Insert the upper hinge shaft (.) into the hole (.). After levelling the upper hinge hole (.) with the hole of the cabinet (.). Fasten hinge screws (.) and screw (.) in the clockwise direc-tion. 4) Connect the wires. 5) Put the front part of the upper hinge cover ( 11 ) on the front part of the upper hinge ( 12 ) and reattach it from the front part of the upper INSTALLATION INSTRUCTIONS hinge cover first. 25 REATTACHING THE REFRIGERATOR DOORS Reattaching the Water Tube (Optional) 1) While pressing the front face of coupler (.), insert the water line (.) in the coupler. 2) Tighten the screw on the clamp ( ).a Reattaching the Front Leg Cover (Optional) Put on the front leg cover by turning the three screws clockwise, as shown in the figure. FRONT LEG COVER SCREW 26 27 INSTALLATION INSTRUCTIONS ADJUSTING THE CLEARANCE BETWEEN THE DOORS The doors will be uneven if the refrigerator is not level. Case 1) Freezer door is lower than that of the refrigerator Insert a straight screwdriver (-) (.) into a slot of the control lever (.), turn it clockwise and level the refrigerator. Case 2) Freezer door is higher than that of the refrigerator Insert a straight screwdriver (-) (.) into a slot of the control lever (.), turn it clockwise and level the refrigerator. Do not make small adjustment by turning the control lever, Please refer to the next page. DIFFERANCE OF HEIGHT DIFFERANCE OF HEIGHT . DRIVER(-) . DRIVER(-) .CONTROL LEVER .CONTROL LEVER Please level the refrigerator first. NOTE ADJUST THE CLEARANCE BETWEEN THE DOORS ADJUST THE CLEARANCE BETWEEN THE DOORS Making small adjustments between doors. Adjustment part . WRENCH . NUT . BOLT . WRENCH . NUT . BOLT . WRENCH . BOLT Please open the doors and adjust the doors as follows: 1) Release the nut (.) on the lower hinge until the upper end of the bolt (.). NOTE When you release the nut(.), use enclosed hex wrench (.) to turn the bolt(.) a little counter clockwise to make the nut(.) loose with your fingers. 2) Please adjust the height difference between the doors turning the bolt (.) turn clockwise( ) or counter clockwise ( ). NOTE When you turn clockwise ( ), the door goes up. 3) After adjusting the doors, turn the nut (.) turn clockwise ( ) until the lower end of the bolt, then tighten the bolt again with the wrench (.) to fix the nut(.). NOTE If you do not fix the nut (.) firmly, the bolt (.) may be released. 28 CHECKING THE WATER DISPENSER LINE (OPTIONAL) 1) In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm2 is required. In this range a 100 cc paper cup can be filled in 10 seconds. 2) The water filter removes particles. It does not sterilize or destroy any micro-organisms. 3) If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm2), you s...
Questo manuale è adatto anche per i modelli :Frigoriferi - RS21DAMS (2.21 mb)
Frigoriferi - RS21DANS (2.21 mb)
Frigoriferi - RS21DASW (2.21 mb)
Frigoriferi - RS21DCMS (2.21 mb)