valutazioni - 2, GPA: 4.5
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
INSTALLATION OF THE WATER DISPENSER LINE SEPARATION OF RED CAP STICKER (MONTH INDICATION) COVER FILTER (A) ALIGN THE INDICATION MARK WITH LOCK POSITION. 1) As shown, the fixed cap separates from the refrigerator by rotating it counterclockwise. Remove the water filter from the box and put a month indicator sticker on the filter as shown. 2) If the water filter was installed in March, put on the "SEP" sticker. 3) Remove the protective cap then position and insert the filter as shown. 4) Slowly turn the water filter clockwise 90. to align the indication mark on the cover, locking the filter in posi tion. Do not overtighten. Please check that the indication line aligns with the lock position. Install the water filter. NOTE 1) Slip the compression nut and plastic ferrule through the plastic tube. 2) After inserting the sleeve, tighten the compression nut onto 1/4” compression fitting(union). Connect the water line to the refrigerator. Water line must be connected to drinkable water only Do not overtighten the compression NOTE nut. Keep the cap(A) in a safe place for recapping, when NOTE you will not use the filter. NOTE 3) Slip the compression ferrule and nut on copper (or plastic) tubing as shown. Tighten the comperssion nut onto the compression fitting(union). 4) Turn water on and check for any leakege. Compression Nut Compression fitting Sleeve Compression Nut Ferrule Ferrule ICE WATER 2) When you press the test button, the ice cube container is filled with water from the water supply tap. Check the amount of water (see the illustration below). If the water level is too low, the ice cubes will be small. This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occurs, contact the dealer service center to check the amount of water supplied. INSTALLATION OF THE WATER DISPENSER LINE Remove any residual matter inside the water supply line after installing filter. Check the amount of water supplied to the ice tray. CHECK THE WATER LEVEL TEST BUTTON TOO HIGH OPTIMUM LEVEL 1) Lift up () and pull out (.) the ice maker bucket in the freezer. ICE MAKER TOO LOW 1) Turn on the main water supply & shut-off valve of the water supply line. 2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines. 3) Additional flushing may be required in some households. 4) Open the refrigerator door and check if water leaks around the water filter. • A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine self (RS2666/2777). TROUBLESHOOTING The refrigerator does not work at all or it does not chill sufficiently • Check that the power plug is properly connected. • Is the temperature control on the display panel set to the correct temperature? Try seting it to a lower temperature. • Is the refrigerator in direct sunlight or located n...
Questo manuale è adatto anche per i modelli :Frigoriferi - 24KLDW (2.07 mb)
Frigoriferi - RS21FANS (2.07 mb)
Frigoriferi - RS24DAMS (2.07 mb)
Frigoriferi - RS24DANS (2.07 mb)