valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
To ensure ventilation, the room in which this appliance is installed must have a suitable opening, like an exterior door or a window that can be opened. When using the household gas cooker, the extractor hood must be operated in such a way, that, the more cooking positions are used, the higher the air output level must be. Electrical Connection Electrical connection (AC 220-240 V) is established by means of a connecting cable with an earthing contact plug connected to an earthed socket, which must also be accessible after installation of the gas hob. If, after installation of the gas hob, not all poles can be isolated from the mains by removing the plug, an isolating device with a contact gap of at least 3 mm must be permanently installed. When establishing connections, make sure that the connecting lead cannot come into contact with hot parts of the gas hob or other hot parts. Turn all control knobs to the OFF position before connecting the appliance to the power supply. The mains connecting cable must at least correspond to type H 05 V2V2 3G 0.75 or it must be correspondingly heat-resistant (at least 90 °C). The mains connecting cable must only be purchased through and connected by an authorised specialist. Pay attention to the information on the rating plate and connect the PE conductor. Connect the connecting cable to the mains. Preparing the Cabinet 442,50 1,4 m 130 8* 914 510 min. 35 min. 30 885 490 min. 50 190 Luftansaugschlitz min. 87,5 max. 122,5*(*SV405-011/012: max. 162,5) 90 60 35 *16.5 at ventilation openings Note: the appliance can be installed in a base cabinet with a minimum width of 900 mm. The recess in the countertop will be slightly wider than the inner width of the base cabinet. Do not install the appliance above a drawer. • Produce the recess for the cooktop in your countertop. Proceed as indicated on the installation sketch. Note: the angle between the cut surface and the worktop must be 90°. • As shown in the installation sketch, drill the O35 mm holes to secure the control knobs in the cabinet front. • If the cabinet front is thicker than 26 mm, the front must be routed from the back to max. 26 mm on an area of 80 x 470 mm. min. 5 min. 5 80 x 470 16 – 26 D = 26 D > 26 Installing the Cooker Please note: if you want to convert the appliance to a different type of gas, change the nozzles before installing the appliance (see pages 27 - 29). • Before installation, remove all styrofoam packaging from the control knobs and peel off the protective film. • Hold the support plate from the rear against the cabinet front (make sure the angled edge of the support plate is on the bottom), insert control knobs into the holes, secure from the rear with the nuts. Take care to install control knobs in the correct order. • Undo trough securing nuts and carefully detach the trough. Note: if a flexible gas connection is being used...
Questo manuale è adatto anche per i modelli :Frigoriferi - KG491110/02 (1.7 mb)
Frigoriferi - KG491110F/01 (1.7 mb)
Frigoriferi - KG491110F/02 (1.7 mb)
Frigoriferi - KG491210/01 (1.7 mb)