valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
Behind the Refrigerator Be careful when moving the refrigerator away from the wall. All types of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces. Turn the leveling legs at each front corner of the refrigerator counterclockwise until the rollers support the refrigerator. Pull the refrigerator straight out and return it to position by pushing it straight in. Moving the refrigerator in a side direction may result in damage to the floor covering or refrigerator. When pushing the refrigerator back, make sure you don’t roll over the power cord or icemaker supply line (on some models). After rolling the refrigerator back into place, turn the legs clockwise until the legs again bear the weight of the refrigerator. Light Bulb Replacement To replace a burned-out bulb, unplug Turning the control to the 0 position does not the refrigerator from its electrical outlet, remove power to the light circuit. unscrew the bulb when cool and replace it with an appliance bulb of the same or lower wattage. Preparing for Vacation For long vacations or absences, remove food and unplug the refrigerator. Move the temperature control dial to the 0 position, and clean the interior with a baking soda solution of one tablespoon (15 ml) of baking soda to one quart (1 liter) of water. Leave the doors open. Set the icemaker power switch to the O (off) position or move the feeler arm to the STOP (up) position (depending on model) and shut off the water supply to the refrigerator. If the temperature can drop below freezing, have a qualified servicer drain the water supply system (on some models) to prevent serious property damage due to flooding. Preparing to Move Secure all loose items such as grille, Be sure the refrigerator stays in an upright shelves and drawers by taping them position during moving. securely in place to prevent damage. 10 If you have questions, call 1.800.432.2737 Installation Refrigerator Instructions Models 16, 17, 18 BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT – Save these instructions for local inspector’s use. • IMPORTANT – Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Consumer. • Note to Consumer – Keep these instructions for future reference. • Skill level – Installation of this appliance requires basic mechanical skills. • Completion time – Refrigerator Installation 15 minutes Reversing the Door Swing 1 hour • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. If the refrigerator has an icemaker, it will have to be connected to a cold water line. A water supply kit (containing copper tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer or from Parts and Accessories, 800.626.2002. WATER SUPPLY TO THE ICEMAKER (on some models) Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections. • Sides 3/4. (19 mm) • Top 1. (25 mm) • Back 1. (25 mm) CLEARANCES • Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures. • Install it on a floor strong enough to support it fully loaded. REFRIGERATOR LOCATION Leveling legs near each front corner of the refrigerator are adjustable. They firmly position the refrigerator and prevent it from moving when the doors are opened. Leveling legs should be set so the front of the refrigerator is raised just enough that the doors close easily when opened about halfway. Turn the leveling legs clockwise to raise the refrigerator, counterclockwise to lower it. Rollers next to the leveling legs allow you to move the refrigerator away from the wall for cleaning. Turn the legs counterclockwise until the weight of the refrigerator is transferred from them to the rollers. After rolling the refrigerator back into place, turn the legs clockwise until the legs again bear the weight of the refrigerator. ROLLERS AND LEVELING LEGS Installation Instructions 1 INSTALLING THE WATER LINE BEFORE YOU BEGIN Recommended copper water supply kits are WX8X2, WX8X3 or WX8X4, depending on the amount of tubing you need. Approved plastic water supply lines are refrigerator tubing kits WX08X10002, WX08X10006, WX08X10015 and WX08X10025. When connecting your refrigerator to a reverse osmosis water system, follow the manufacturer’s recommendations. This water line installation is not warranted by the refrigerator or icemaker manufacturer. Follow these instructions carefully to minimize the risk of expensive water damage. Water hammer (water banging in the pipes) in house plumbing can cause damage to refrigerator parts and lead to water leakage or flooding. Call a qualified plumber to correct water hammer before installing the water supply line to the refrigerator. To prevent burns and product dama...
Questo manuale è adatto anche per i modelli :Frigoriferi - 17 (1.48 mb)
Frigoriferi - 18 (1.48 mb)