valutazioni - 3, GPA: 3 ( )

Produttore : Altec Lansing File Size : 156.3 kb File Nome : c71dc521-1af0-432e-a6b6-24f0de843fea.pdf Lingua di insegnamento:

Temporarily fasten the stiff paper template (supplied) to the wall with thumbtacks. Carefully trace around the perimeter with a pencil. Before making the final cutout of the entire hole, first make a small 4-inch"test" cutout in the center of your penciled outline. Reach your hand inside to verify that studs are outside the outline. This is an important step, since stud finders are not infallible. To cut the actual hole, first score wallboard with a sharp knife; then use a keyhole saw to complete the cut. Remove remaining debris from the edges. Hold the speaker up to the cutout to make sure it inserts easily without forcing. At this point, it is a good idea to secure the speaker wire to a stud near the cutout so its own weight will not tug on the terminals of the speaker after it is connected. This will also prevent you from losing the wire in the wall. Before attaching the wire, make sure the speaker wire runs through, not around, the metal mounting bracket. final installation 1. Use the supplied cut-out templates to outline the mounting holes to be cut in the wall. Be sure the intended hole is square and plumb. Remove the perforated section out of the center of the template. Save this section, it will serve as a painting mask if you wish to paint the speaker in the wall. Use the inside edge of the remaining section of the template to mark the hole size 2. Cut the hole. 3. Route the speaker wire from the amplifier to the speaker installation location. Secure the wires to prevent them from falling into the wall before the speaker is mounted. 4. Adhesive-backed foam strip-gaskets are supplied with the packing materials. These will be used to line the back of the mounting collar flange. Remove the speaker from the corrugated shipping sleeve. Peel the backing from the foam strip-gaskets and place them along the back of the mounting collar flange. Cut them to size if necessary. Be sure to butt the strips up against each other to prevent possible air leakage. Once the strips are positioned properly, press them firmly into place. NOTE: this step is not necessary if you are installing the speaker into sheet-rock. Sheet-rock is soft enough to compress and naturally seal the gap. 5. Separate the two wire conductors from each other. Strip away approximately 1/4” of insulation from each of the wire conductors. Twist the strands together into neat bundles. 6. Push the positive (+/red) terminal to open the wire hole. Insert the positive conductor and release the terminal to lock the wire into place. Be sure not to insert the conductor too far causing the terminal to lock down on the insulation instead of the wire strands. Perform this same task for the negative (-/black) terminal as well. 7. Insert the speaker assembly on an angle so that one of the mounting brackets enters the opening first. (fig. 1) fig1 8. Turn the speaker toward the wall so that the other mounting bracket enters the mounting hole and the speaker is seated on the wall. (fig. 2) fig2 9. Hol...

Scarica la tua

Per scaricare, digitare 2 cifre :