valutazioni - 2, GPA: 3 ( )

Produttore : Altec Lansing File Size : 156.3 kb File Nome : Lingua di insegnamento:

Debris and loose material can cause buzzing or rattling, and can damage the woofer cone. Install plastic or fiberglass screening above the speaker to keep debris away. Handle the speaker carefully. Do not let anything touch the speaker cone or dome. Do not clean the speaker with paint thinner or any solvents. • Consider the services of a professional custom installer. If you have any doubts about your own abilities, it is better not to risk damaging your walls or ceilings, electrical wiring, ventilation ducts or plumbing. • Work with good quality, correct tools. This will save you time and assure superior results. • Allow sufficient clearance. • When using speakers outdoors, locations should be sheltered from direct sunlight, rain or snow. Direct exposure will shorten product life. • Combined impedance for speakers connected to each channel should be at least 4 ohms. This is the minimum impedance tolerated by most amplifiers. Check with your dealer before wiring multiple speaker pairs. general mounting suggestions Avoid placing the speaker within two feet (0.6 meters) of a corner. The acoustic reflections from surfaces near the speakers can detract from the sound quality. Do not place the speaker behind heavy fabrics; if you cannot see through a fabric, you cannot hear through it. The in-wall speakers are designed for "infinite baffle" operation. The area behind the speaker installation should be at least one-half cubic foot in volume to ensure proper performance. If the area is too small it will limit bass response and cause a peak in the mid-bass range. prewiring • Check local building and electrical codes for compliance of the speaker wire. • Use stranded wire of at least 16 gauge; for runs over 100 feet, it is preferable to use 14 gauge wire. • Use only insulated staples or nylon tie straps to secure wiring within the wall to avoid shorts. • Do not stretch the wire as it is being routed. This could create future (and costly) problems. • Leave about 2-3 feet of free wire at both ends. Cutting excess wire is better than splicing. • Always "home run" wires: run a continuous wire from each speaker directly to the source location. Do not connect speakers together any other way for easier diagnosis of faulty wire or speaker problems. • Wire speakers in phase with the same polarity. Attach positive (+/red) and negative (-/black) terminals consistently. • Combined impedance for speakers connected to each channel should be at least 4 ohms. This is the minimum impedance tolerated by most amplifiers. Check with your dealer before wiring. preparing the wall or ceiling cutout Confirm there is at least 1" between the final cutout and nearby studs or joints for positioning mounting hardware. Temporarily fasten the stiff paper template (supplied) to the wall with thumbtacks. Carefully trace around the perimeter with a pencil. Before making the final cutout of the entire hole, first make a small 4-inch"test" cutout in the center of your penciled outline. Reac...

Scarica la tua

Per scaricare, digitare 2 cifre :