valutazioni - 4, GPA: 4
(
)
)
|
Facilità d'uso
Interior lighting: The lighting automatically switches off after the door has been open for . Remove the cover . over the filter, use a screwdriver if necessary. . Remove the old filter . and replace with a new active charcoal filter. . Replace the cover . over the new filter. After cleaning . Return all bottles to the appliance. . Insert the plug into the power outlet and turn on the appliance at the main switch. approx. 5 minutes. This is not a fault. After the bulb has cooled for a short time it will turn on again. If the light does not come on when the door is opened briefly, the light bulb should be changed. . Use the main switch to turn the appliance off. To reduce the risk of electric shock, disconnect the appliance from the power supply by unplugging or tripping the circuit breaker. . Turn the light cover counterclockwise and pull out. Cleaning and care Never touch a halogen bulb with bare fingers. When inserting a glass halogen bulb, always hold with a soft cloth. . Pull the defective light bulb from the socket. . Place the new bulb in the socket. Halogen bulb type: 5 W/12 V/socket G 4. . Put the light cover back on and turn clockwise into place. Restore power to the appliance. Frequently asked questions With the aid of the following guide minor problems can be corrected without a service call. Repairs should only be carried out by a qualified and trained person in strict accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage and may void the warranty. What if the appliance does not get cold? Possible fault Solution The machine is not turned on. Check whether the appliance is switched on at the main switch. The machine is not plugged in. Check that the plug is correctly inserted in the power outlet. Check that the fuse has not tripped. Reset the circuit breaker. If the breaker trips again the appliance or the outlet may be defective. Contact Miele or a qualified electrician. The temperature is set incorrectly. Check the display. What if the temperature is too low? Select a warmer temperature. See "Setting the temperature". The door is not closed. Check that the door has been closed properly. A large amount of bottles has been put in the appliance at the same time. This makes the compressor run for longer, causing the temperature in the appliance to fall automatically. What if the compressor kicks on very frequently and for too long? The ventilation slits in the plinth and in the top of the appliance are covered or dusty. Clean with a vacuum or brush. The door has been opened too frequently. Once the appliance returns to the set temperature the compressor will turn off. The door is not closed. Check that the door has been closed properly. Frequently asked questions What if the alarm is ringing? Possible fault Solution The appliance door has been open for longer than 5 minutes. Close the door. What if the alarm is ringing and the "alarm" indicator is lit? The door is not closed. One of these conditions has caused the temperature in the appliance to become too warm. Once the alarm condition has been corrected, the alarm will turn off and the "alarm" indicator will stop flashing. The ventilation slits are covered. A large amount of wine was stored at once. There has been a power failure. What if a fault message with"_F" appears in the temperature display? A fault has occurred. Contact Miele Technical Service. What if the display lighting is not working? The display lighting turns off automatically depending on the time set. See "Display lighting". If the display lighting still does not turn on after 15 minutes with the door closed, contact Miele Technical Service. A white coating has formed around the wine corks. The corks are made of a material which has caused a chemical reaction (oxidation). The white coating can be removed with a dry cloth. The coating has no effect on the quality of the wine. Mildew is beginning to form on the wine bottle labels. Depending on the type of adhesive used mildew may begin to form on the labels. Wash the wine bottles and remove any adhesive residue. Frequently asked questions The appliance is making noises. Issue Possible fault Solution Brrrrr... Humming noise made by the compressor. This noise can get louder for brief periods when the motor is switching on. These noises are not a fault. The noise of the compressor and the coolant circulating in the system is unavoidable. Blubb, blubb... A gurgling noise can be heard when coolant is circulating through the pipes. Click... Clicking sounds are made when the thermostat switches the compressor on and off. Sssrrrrr... On multi-zone and frost-free appliances you can sometimes just hear the movement of air circulating inside the appliance. Creaking Creaking sounds can be heard when material inside the appliance expands. Rattling, vibrating The appliance is uneven. Realign the appliance using a level, by raising or lowering the screw feet underneath the applian...
Questo manuale è adatto anche per i modelli :Dispenser - KWT1601SF (1.36 mb)