valutazioni - 3, GPA: 3.7
(
)
)
|
Facilità d'uso
. Pull out the empty wooden rack (along with the rails) as far as the stop, then lift it up and out. . To replace the racks, set them on the extended rails so that they click into place. Be sure that the ventilation slits at the rear of the unit are not blocked. They are essential for the unit to operate properly. Storing wine Bottle display rack The display rack, allows you to display selected bottles so they can be seen even with the door closed. . Lay the wine bottles in the display rack, so that they touch the wooden guide-rail . . To remove the display rack pull it up and out, then attach it to the rear position on the wooden rack . The bottles can now be stored on the wooden rack in the usual manner. Additional display racks are available from Miele. The display rack can only be attached to wooden racks with wide cross-ties. In the upper temperature zone, these are found in the lower position. In the lower temperature zones, they are found in both the upper and lower position. It is recommended that the wooden racks always be left in the pre-set positions. This makes optimal use of the interior space. Never stack bottles on the wooden racks. Only the bottom-most level in each temperature zone can support a stack of bottles (remove the wooden rack). Maximum capacity The unit can hold approx. 102 bottles (0.75 l). Storing wine Display lighting The display lighting can be turned on if you wish the bottles to be lit up even when the door is closed. Turning on . Touch the access button ""soit turns yellow. . Touch the "Display light" sensor button so that it turns yellow. The display lighting will now remain on in the 2 lower temperature zones, even when the door is closed. When the door is open, the interior lighting also comes on in all three temperature zones. Turning off . Touch the "Display light" sensor button so that it turns white. The display lighting is now turned off. When the door is closed, the interior is dark, and when the door is opened the interior lighting comes on. Duration of the display lighting The display lighting is factory pre-set to 30 minutes. . To change this time setting, press and hold the "Display light" sensor button for 2 seconds. The set time (in minutes) appears in the display: Use the . and . buttons next to the display to change the duration of the lighting in increments of 15 minutes. You can set the lighting to last for 15, 30, 45, 60, 75 or 90 minutes. . To confirm the setting touch the access button "" until all the displays go out. If the door is closed before the set time is completed, the lighting duration starts over again from the beginning. Defrosting During normal operation, condensate and frost can form on the rear wall of the refrigerator and drawers. You do not need to remove this build-up, it will defrost and evaporate automatically with the heat generated by the appliance. Cleaning and care To reduce the risk of electrical shock, disconnect the appliance from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before maintenance. Never use cleaning agents containing abrasive substances such as sand, soda, acids, chlorides or chemical solvents. Non-abrasive cleaning agents are also unsuitable, as they can cause matte areas to appear. Avoid getting water on the solid wood facing or the shelves. Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner (available from Miele). Do not use a steam cleaner to clean this appliance. Pressurized steam could penetrate electrical components and cause a short circuit. Do not allow water to get into the electronic unit or lights. The data plate located inside the appliance must not be removed. It contains information which is required in the event of a service call. To better maintain your appliance avoid the following: – cleaners containing soda, ammonia, thinners, or chlorides – cleaners containing descaling agents or lime removers, – abrasive cleaners, – dishwasher soap (powder), – caustic (oven) cleaners, – scouring pads, steel wool, hard brushes, – glass cleaners (with the exception of the glass door front), – metal scrapers, – eraser sponges, – steam cleaning products. Glass cleaners may be used to clean the exterior. However do not allow them to sit or "puddle", this can cause damage to the surface. Remove the cleaner promptly. Cleaning and care Before cleaning . Use the main switch to turn the appliance off completely. The main switch is located on the right side underneath the control panel. . Unplug the power cord. . Remove any bottles from the appliance and store it in a cool place. . Take out any removable parts, e.g., shelves. Cleaning the interior . It is recommended to clean the interior once a month. . Use a mild solution of warm water and liquid dish soap. . Clean the wooden racks with a damp cloth. Do not allow the racks to become too wet. . After washing, wipe down the interior and accessories with a clean wet cloth, t...
Questo manuale è adatto anche per i modelli :Dispenser - KWT1611SF (1.36 mb)