valutazioni - 3, GPA: 3.7 ( )

Produttore : Panasonic File Size : 3.95 mb File Nome : KXFLM661.PDF Lingua di insegnamento:

Select] dialog box when operating the following functions. – Scanning – Remote Control – PC FAX – Device Monitor For assistance, please visit 12.12. 12.3.2 Printing problems Problem Cause & Solution The printing quality is poor. ABC L Some paper has instructions recommending which side to print on. Try turning the recording paper over. L You may have used paper with a cotton and/or fiber content that is over 20 %, such as letterhead or resume paper. L The recording paper is too damp. Use new paper. L The remaining toner is low. Replace the toner cartridge. L To check the drum life and quality, please print the printer test list (page 80). If printing quality is still poor, replace the toner cartridge and/or drum unit. L The toner save mode of feature #482 is ON (page 52). A blank sheet is ejected. L You placed the document facing the wrong way when using the copier. L The other party placed the document in their fax machine the wrong way. Check with the other party. Black lines, white lines or smudges appear on the printed documents. L The glass or rollers are dirty with correction fluid, etc. Clean them (page 78). Please do not insert a document before correction fluid has dried completely. Colored and gray objects are printed in black instead of grayscale when printing from Microsoft PowerPoint or other applications. L Select [Color] or remove the check next to [Grayscale] in the print dialog so that colored or gray objects will be printed in grayscale properly. When using the unit as a printer, the printing result is distorted. L Your unit is connected to the computer by USB. After canceling printing using your computer, you must wait for 60 seconds before re-printing to avoid distorted printing. 12.3.3 Scanner Problem Cause & Solution I cannot scan. L When scanning at a high resolution, a large amount of available memory is required. If your computer warns that there is insufficient memory, close other applications and try again. L The unit is in use. Try again later. L There is not enough space on the hard disk. Delete unnecessary files and try again. L Check the connection between the computer and the unit (page 17, 24). L Restart the computer, and try again. L You attempted to scan a document longer than the paper size which you set. Change the setting or divide the document into the appropriate paper size, and try again. The document is not fed into the unit when using the unit as a scanner. L Remove the document and re-insert it. Even after clicking [Cancel], scanning continues. L Please wait. It may take a while for the cancel request to be accepted. For assistance, please visit 12. 12. Problem Cause & Solution The name of the desired computer will not be displayed on the unit when scanning documents from the unit (KX-FLM671, LAN connection only). L The printer driver has not been installed. Install it on your computer (page 23). L The PC name list up feature has been set to [Off]. Set [PC name list up on device] to [On] (page 26). L The maximum number of computers on the LAN is connected to the unit (up to 30 computers). Set [PC name list up on device] to [Off] on the other computers (page 26). L The IP address of the unit may have changed. To detect the IP address, proceed as follows. [Start] i [All Programs] or [Programs] i [Panasonic] i the unit’s name i [IP Address Checker] L The IP address for the unit will be detected. 12.3.4 Copier Problem Cause & Solution The unit will not make a copy. L You cannot make a copy during programming. Make the copy after programming. L The document was not fed into the unit properly. Re-insert the document. L Recording paper is not installed or the unit has run out of paper. Install paper (page 15). Letters on the copied documents are not clear. L The original document is too dark or too light. Change the contrast (page 33) and try again. The copied documents are too dark and cannot be read. L You used a colored paper as a document. Change the contrast (page 33) and make a lighter copy of the document, using “TEXT” resolution (page 33). 12.3.5 Fax Problem Cause & Solution I cannot send documents. L The telephone line cord is connected to the [EXT] jack on the unit. Connect to the [LINE] jack (page 17). L The other party’s fax machine is busy or has run out of recording paper. Try again. L The other party’s machine is not a fax machine. Check with the other party. L The other party’s fax machine failed to answer the fax automatically. Send the fax manually (page 38). I cannot send a fax overseas. L Use the overseas transmission mode (feature #411 on page 53). L Add two pauses at the end of the telephone number or dial manually. The other party complains L If your line has special telephone services such as call waiting, the service that letters on their received may have been activated during fax transmission. Connect the unit to a line document are distorted. that does not have these services. L Anoth...

Scarica la tua

Per scaricare, digitare 2 cifre :