valutazioni - 4, GPA: 4.8
(
)
)
|
Facilità d'uso
THIS INFORMATION SHALL BE OBTAINED BY CONSULTING YOUR LOCAL GAS SUPPLIER. THE APPLIANCE AND ITS INDIVIDUAL SHUT OFF VALVE MUST BE DISCONNECTED FROM THE GAS SUPPLY PIPING SYSTEM DURING ANY PRESSURE TESTING OF THAT SYSTEM ATTEST PRESSURES IN EXCESS OF 1/2 PSIG. (3.45 KPA). THE APPLIANCE MUST BE ISOLATED FROM THE GAS SUPPLY PIPING SYSTEM BY CLOSING ITS INDIVIDUAL MANUAL SHUT OFF VALVE DURING ANY PRESSURE TESTING OF THE GAS SUPPLY PIPING SYSTEM AT TEST PRESSURES EQUAL TO OR LESS THAN 1/2 PSIG. (3.45 KPA). RETAIN THIS MANUAL FOR YOUR REFERENCE. 9110 REVL2 1 422-01TE GENERAL INFORMATION The serial plate is located on the left hand box cover. Remove front liftoff cover for access. Gas type, burner ratings and electrical requirements are stated on the plate. 1. Damage check: always check carton or crate for possible damage incurred in shipping. After carefully uncrating, check for "concealed" damage. Report any damage immediately to your carrier. 2. 208/240 volt units are equipped with a circuit breaker. Should it be necessary to reset the breaker, the reset button is located in the centre of the right control box. Remove front panel for easy access. 3. The correct type of gas for which the unit was manufactured is noted on the rating plate, and this type of gas must be used. 4. A pressure tap is supplied with the unit just before the pilot solenoid valve which is installed on the manifold The gas pressure must be checked when unit is installed, to ensure unit gas pressure is the same as specified on rating plate. For access to the pressure tap, remove front panel, turn power switch to the "OFF position as a precaution, and remove the two self tapping screws which secure the left control box cover. Turn power switch and thermostat to the "ON" position (using extreme caution) and complete pressure test If necessary, pressure adjustments can be made at the pressure regulator which is installed on the manifold. For easy access to the pressure regulator, view along left side of unit from underneath. Once pressure test is completed, turn power switch and thermostat to the "OFF position and replace control box cover using self tapping screws removed earlier. 5. Have a qualified gas technician check the gas pressure to make certain that existing gas facilities (meter, piping, etc.) will deliver the BTLTs of gas required at the unit with no more than 1/2" water column pressure drop. When checking pressure, be certain that all the equipment on the same gas line is turned to the "ON" position. 6. Make certain that new piping joints and connections have been made in a clean manner and have been purged, so that piping compound, chips, etc, will not dog pilots, valves, and/or controls. Use pipe joint sealant that is approved for use with liquified petroleum gas. 7. WARNING: Always check gas connections for leaks using soap solution or like means. DO NOT CHECK WITH OPEN FLAME. INSTALLATION CLEARANCES This unit must be installed in accordance with the following clearances in order to provide proper operation and servicing of the appliance. Also, it is recommended that unit be installed with sufficient clearances to provide for proper cleaning and maintenance. ...
Questo manuale è adatto anche per i modelli :Friggitrici - SGL-T (1.11 mb)
Friggitrici - SGL-T (1.11 mb)
Friggitrici - SGL-T (1.11 mb)
Friggitrici - SGM-T (1.11 mb)