valutazioni - 2, GPA: 5
(
)
)
|
Facilità d'uso
Checks before each operation: Before use, an inspection is always to be performed In order to determine that all nuts, bolts and working tools are not worn down or damaged. Worn down or damaged blades are to be replaced in sets. Inspect the surface on which the lawn mower is to be used be-forehand. Stones, pieces of wood and wires as well as other solid matter are to be removed. Objects, which are contacted bythe cutting tools, could be thrown out uncontrollably. Proper use / Responsibility Warning ! Take note that the rotating blade cylinder could cause injuries. V VVNever place your hands or feet on or under moving parts. 8 Do not use the lawnmower while people, especially children or animals, are directly nearby. The operator is liable for damages. The safety distance between the blade cylinder and the operator that is created by the guiding spar is to be always maintained. When mowing embankments and slopes, special care is to be taken: v make sure you always have a safety distance and wear shoes with a non slip sole. 3. Assembly Always cut diagonally to the slope. Take special care when moving backwards and when pulling the lawn mower. Danger of stumbling! If the cutting tools or the lawnmower should run into an obstruction and/or solid objects, the lawn mower should be properly and thoroughly inspected. v Only work when visibility is good. Never leave the lawnmower unattended. If your work is interrupted, store the mower in a safe place. GB 4. Operation 3421 1. Squeeze lower part of upright 1 together gently until it snaps into the pins b. 2. Push U-shaped retaining washer zon to the groove S on the bolt b. 3. Screw middle parts of upright 2 firmly to lower part of upright 1 with 2 wing nuts 3. 4. Screw upper part of upright 4 to middle parts of upright 2 with 2 wing nuts 3. 1b zS Mowing correctly: To produce a well-maintained lawn we recommend cutting the lawn regularly one a week if possible. The lawn becomes thicker if cut frequently. Relatively long cut grass (> 1 cm) must be removed so that the lawn does not become yellow and matted. After relatively long intervals between mowing (holiday lawn), first of all cut in one direction with the cutting height as high as possible (42 mm), then cut in the crosswise direction at the cutting height required. The blades of grass may not be more than 12 cm long if they are to be cut with a cylinder mower. If possible, only cut the grass when it is dry, if the grass is damp, the cutting pattern will be uneven. 9 GB Adjusting the cutting height: 566 The cutting height can be set to any position between 12 mm and 42 mm. 1. Stand behind the cylinder mower with one foot on the roller 5. 2. Release the two locking screws 6 and adjust to the correct height in the inspection window 7. 7 3. Tighten the two locking screws 6 on both sides to the same height. The locking screws 6 must always be set to the same height on both sides. The mower may only be adjusted to a depth in which the lower blade does not tou...
Questo manuale è adatto anche per i modelli :falciatrici - 380 (114.36 kb)
falciatrici - 300 (114.36 kb)
falciatrici - 300 (114.36 kb)
falciatrici - 300 (114.36 kb)