valutazioni - 2, GPA: 4 ( )

Produttore : Monessen Hearth File Size : 2.39 mb File Nome : Lingua di insegnamento:

To check for venting action, start by holding a smoke producing devicebelow the glass enclosure panel. The smoke should be drawn into the control compartment. Continue thetest by moving the smoke producing device along the entire length ofbelow the glass door. 6. If the smoke is not drawn into the control compartment, turn off the appliance and call a qualified service technician. RESETTING THE SAFETY LIMIT SWITCH This appliance is equipped with a manually resetable safety limit switch. Refer to Figure 34 for its location. If, during appliance operation, the flame goes out (independently of the burner on/off wall switch), it may be due to a blocked vent. If this condition occurs, the safety limit switch will activate, causing the fireplace burner to shut off. To reset this switch, first allow the appliance to cool, then remove the top louver panel. Reset the safety limit switch by pushing the red reset button, located between the wire terminals on the back of the switch (See Figure 34, Detail A). The appliance should then relight and remain lit. Reinstall the top louver panel. If the appliance does not relight, turn off the appliance and call for a qualified service technician. To replace the blocked flue safety limit switch (see Figure 34, Details B & C). This procedure should only be performed by a qualified service technician. IMPORTANT - TURN ELECTRICAL POWER OFF BEFORE BEGINNING THIS PROCEDURE. 1. Lower the bottom control compartment access panel. Remove the glass enclosure panel: open the latch (located in the center of the unit front opening, under thefi rebox fl oor) securing the glass enclosure panel. Remove the panel by tilting it outward at the bottomand lifting it up. Set the door asideprotecting it from inadvertent damage (see Figure 29 on Page 19). 2. Remove the lintel securing screws (3) and then remove the lintel. One of the lintel cabinet top holes is shown in Figure 34, Detail B. 3. Remove the scoop securing screws (3) and then remove the scoop (seeFigure 34, Detail B). 4. Remove the safety switch bracket securing screws (2), and pull theswitch/bracket assembly, with low voltage wires attached, through the side panel slot into the fi rebox (seeFigure 34, Detail C). 5. Replace the switch. 6. Reinstall the switch/bracketassembly. 7. Reinstall the scoop and lintel. 8. Reinstall the glass enclosure panel. 9. Raise the bottom control compartment access panel. 10. The appliance should then relightand remain lit. If this does not occur, check unit for a blocked fl ue condition. Detail A Wire Terminals Back Of Limit Switch Cabinet Corner Door Frame Reset Button Lintel Securing Screw Hole in Cabinet Top Scoop Scoop Securing Screws Firebox Top Detail B Detail C Blocked Flue Safety Limit Switch Location, InsideView of Firebox, Top/Right Side Intersection Firebox Top Limit Switch Limit Switch/Bracket Securing Screws Lintel Securing-Screw Hole in Cabinet Top View Without Scoop Figure 34: Safety Limit Switch STEP 13. HOOD INSTALLATION Refer t...

Scarica la tua

Per scaricare, digitare 2 cifre :