valutazioni - 2, GPA: 4 ( )

Produttore : Heat Controller File Size : 708.5 kb File Nome : Lingua di insegnamento:

(The monitor operation range is ±4 °F relative to the thermostat setting.) . If the mode automatically selected by the unit is not satisfactory, see page 3 for instructions on changing the mode setting (HEAT, COOL, FAN). * Heating: . Use to warm your room. . When Heating mode is selected, the air conditioner will operate at very low fan speed for about 3 to 5 minutes, after which it will switch to the selected fan setting. This period of time is provided to allow the indoor unit to warm up before begin full operation. . When the room temperature is very low, frost may form on the outside unit, and its performance may be reduced. In order to remove such frost, the unit will automatically enter the defrost cycle from time to time. During defrosting (see page 15), the heating mode will be temporarily interrupted. DEFROST will be shown on the remote controller display. Cooling: . Use to cool your room. Fan: . Use to circulate the air throughout your room. * During Heating mode: Set the thermostat to a temperature setting that is higher than the current room temperature. The Heating mode will not operate if the thermostat is set lower than the actual room temperature. During Cooling mode: Set the thermostat to a temperature setting that is lower than the current room temperature. The Cooling mode will not operate if the thermostat is set higher than the actual room temperature (in Cooling mode, the fan alone will operate). En-4 TIMER OPERATION (OFF TIMER/ON TIMER) Before using the timer function, be sure that the remote controller is set to the correct current time and Day. Press the START/STOP button; after the unit starts operation perform the following procedure: OFF Timer / ON Timer Press the TIMER MODE button and display either OFF Timer or ON Timer. The timer will start operating. (If you set the ON timer, the air conditioner will stop operating). Each time the button is pressed the timer function changes in the following order: sNON STOP (RESET)sOFF sON sWEEKLY 2 2 Press the SET TIME button and set the timer time. ^ : Use to advance the time forward. Ў : Use to turn the time back. (Press once to move the time 1 minute; hold down and the time will move 10 minutes at a time.) To confirm or Change Settings Before Starting Operation . To confirm settings Press the TIMER MODE button once. (The timer setting information will be displayed for 15 seconds after the TIMER MODE button is pressed.) . To change settings Confirm the settings as noted above, then press the SET TIME button and TIMER MODE button as necessary to change the desired timer setting. (The timer settings will be displayed for 15 seconds after the button is pressed.) . After confirming or changing the settings, press the START/STOP button to start operation. To Change the Timer Setting During Operation Operate as noted in step 2. To Change the Timer Mode During Operation Press the TIMER MODE button and set the unit to the desired mode. °F AM CLOCK PM TIMER OFF TIMER OFF COOL TIMER MODE...

Scarica la tua

Per scaricare, digitare 2 cifre :