Log:
Scaricare : 1   File Size : 842 kb   Produttore : Campbell Hausfeld  
Categoria : Jig Saw e
@name@name@name

different from those intended could herramienta este apagada. Desenchufe profundidad del corte para que 1. Comenzando en una esquina, alinee result in a hazardous situation. Remove la herramienta. La placa base puede pieza de trabajo, no a traves de los Incline la sierra hacia adelante, ajustarse hasta 45., soltando la perilla solamente pueda cortar a traves de la la linea de guia con su linea de corte. any Disconnect the plug from the power 1. Do NOT use any abrasive wheels. soportes. fijando c

Scaricare : 0   File Size : 832 kb   Produttore : Campbell Hausfeld  
Categoria : Jig Saw e
@name@name@name

Many accidents are caused by poor- Funcionamiento (Cont.) vez que haya cortado el bolsillo, • La porcion expuesta de la barra de General Power Tool ly maintained power tools. If the blade becomes twisted or la sierra se debe mantener limpia. misaligned in the cut, the teeth at the acerquese a la esquina desde la Keep back edge of the blade can dig into 2. Corte por penetracion: Elimine frecuentemente los restos Safety Warnings (Cont’d.) direccion contraria y corte el angulo. cutting the top surf

Scaricare : 0   File Size : 598 kb   Produttore : Campbell Hausfeld  
Categoria : Jig Saw e
@name@name@name

. 1. Boring a starting hole: For internal cutouts without a lead-in cut from an edge, pre-drill a starting hole 12 mm (1/2") or more in diameter. Insert the blade into this hole to start your cut. 2. Plunge cutting (see Figure 4): You need not bore a starting hole or make a lead-in cut if you carefully do as follows: a. Tilt the tool up on the front edge of the base with the blade point positioned just above the workpiece surface. b. Apply pressure to the tool so that the front edge of the base

Scaricare : 5   File Size : 588 kb   Produttore : Campbell Hausfeld  
Categoria : Jig Saw e
@name@name@name

BASE ADJUSTMENT Always be sure that the tool is switched off. Unplug tool. The base can be adjusted up to 45° by loosening the base adjustment bolts on the underside of the saw. Align to the desired angle on calibrated quadrant. Then tighten base adjustment bolts (2). Because of the increased amount of blade engagement in the work and decreased stability of the base, blade binding may occur. Keep the saw steady and the base firmly on the workpiece. BEVEL CUTTING !CAUTION Always be sure that the

Scaricare : 0   File Size : 429 kb   Produttore : Campbell Hausfeld  
Categoria : Jig Saw e
@name@name@name

velocidad variable. (Figura 3) 14 Sp 3 Operating Instructions and Parts Manual Blade retainer screw access hole Figure 3 Blade Blade Guard Guard Adjustment Warning DecalScrews (2) (opposite side) Power switch Lock Variable Speed Switch Power Switch Assembly (cont’d.) 8. Resume normal operation. Before plugging in power cord, always pull on the blade to make sure it is securely locked in the clamp. Failure to do so may result in serious injury. Operation Power Switch: To start saw, push in power





categorie