valutazioni - 1, GPA: 3
(
)
)
|
Facilità d'uso
Loosen the two screws in the clamping bracket, then place it over 3® Ski Mirror 9083 Installation Instructions SAVE THESE INSTRUCTIONS Form Number 69212T Rev. B 03-10 FEATURES The Attwood Ski Mirror is designed with a universal mount which allows mounting on either the dash or windshield extrusion (up to 3/4" thick). It adjusts freely to any position, any angle, up or down or side to side. The design includes a shatterproof convex lens that eliminates blind spots. It is compact and lightweight. The spring-loaded ball joint holds mirror firm to prevent vibrating out of position. Also features gleaming ZAMAK with Perma-Plate® chrome finish. DASH-MOUNTED SKI MIRROR Tools and Materials Required for Installation 1. Drill and drill bits. 2. Two #10 x 3/4" stainless steel wood/sheet metal pan-head screws (not included). 3. Phillips Head screwdriver. INSTALLATION INSTRUCTIONS 1. Select a desirable location at or near centerline of the boat, making sure there is enough room to work before drilling. (Figure 1) Figure 1 Adjust Tighten Center of Dash Screws 2. Mark the hole locations using the base as a template. 3. Drill two suitable sized holes. 4. With mirror in place, use two #10 screws and fasten to dash. 5. After mirror is mounted, adjust to desired position. If mirror cannot be adjusted sufficiently, rotate the mirror head one-half turn. (The mirror may need to be removed from the dash to do so.) NOTE: Mirror head tension does not require adjustment; a permanent tension system is built in and preset by Attwood. WINDSHIELD-MOUNTED SKI MIRROR NOTE: Windshield installation is notrecommended for frameless windshields. Tools and Materials Required for Installation 1. Phillips Head screwdriver. 2. Optional metal cutting file. 3. Optional aluminum, plastic, plywood spacer. INSTALLATION INSTRUCTIONS 1. Select a desirable location at or near centerline of the windshield. the windshield frame and mirror base at the selected location. (Figure 2) OPTION 1 For windshield frames less than .450" thick, or a stepped frame (Figure 3), a small spacer of aluminum, plastic, or marine plywood may be used between the base and the windshield frame. OPTION 2 For windshields with a stepped frame (Figure 3), using the mounting bracket as a template, mark the width of the bracket on the windshield frame step. Using a file, remove the step from this area. Figure 2 Tighten Screw Adjust Windshield Frame Figure 3 Step Step 3. Tighten two clamping bracket screws. CAUTION: Overtightening the screws could cause damage to the threads, clamping bracket, windshield/windshield frame. 4. After mirror is mounted, adjust to desired position. If mirror cannot be adjusted sufficiently, rotate the mirror head one-half turn. (The mirror may need to be removed to do so.) NOTE: Mirror head tension does not require adjustment; a permanent tension system is built in and preset by Attwood. ATTWOOD LIMITED WARRANTY Attwood Corporation, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that Attwood brand products will be free from defects in materials and workmanship under normal use and service for one year from the date of original consumer purchases. This limited warranty is not applicabl...
Questo manuale è adatto anche per i modelli :Barche - 69212T (445.56 kb)