valutazioni - 5, GPA: 4.4
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
The AUX controls can be used to determine the amount of signal from the corresponding input channel sent to external effect devices or power amps fed by the AUX SEND jacks. • AUX 1 is factory pre-wired for pre-EQ/pre-fader operation, so the AUX 1 signal is not affected by the setting of the channel EQ controls' or fader. An internal jumper allows the AUX 1 control to be rewired for post-EQ/post-fader operation. • AUX 2 and AUX 3 are factory/ pre-wired for post-EQ/ post-fader operation, so the AUX 2 and AUX 3 signals are affected by the setting of the channel EQ controls and fader. Internal jumpers allow the AUX 1 control to be rewired for pre-EQ/pre-fader operation. • An internal post-EQ jumper allows the AUX controls to be further re-configured for post-EQ/pre-fader operation. • REFER THE ABOVE-MENTIONED REWIRING JOBS TO QUALIFIED YAMAHA SERVICE PERSONNEL! © PAN pot The PAN pot determines the position in the stereo sound field at which the sound from that channel is heard. When it is rotated fully counterclockwise, the channel signal will be delivered from the left stereo output only, and will be heard at the far left of the sound field. If the PAN pot is turned fully clockwise, the sound from that channel will appear at the far right of the stereo sound field. If the PAN pot is set at its center position, the channel signal will be sent equally to both the left and right channels, causing the sound to appear at the center of the sound field. Intermediate PAN pot settings cause the sound to be heard at the corresponding position. ® Channel CUE switch When the CUE switch is pressed, the pre-EQ/pre-fader signal from that channel is fed to the PHONES output via the CUE/PHONES level control. The channel cue signal will be added to any other active cue signal. If you want to monitor only the signal from a single channel, make sure all other CUE switches are turned OFF. • The CUE buss is factory-wired to be fed with a pre-EQ signal. This can be changed by internal jumpers to be post-EQ. • REFER THE ABOVE-MENTIONED REWIRING JOB TO QUALIFIED YAMAHA SERVICE PERSONNEL! © Channel ON switch The ON switch on each channel switches the channel signal to the L and R stereo busses, the MIX outputs, the three AUX send busses. When ON (depressed), the channel signal will be sent to all these busses. When OFF, the channel’s signal will be silenced. It is therefore possible to use this switch as a mute switch to avoid unwanted microphone overspill in quiet passages, for example. © Channel fader This is the main level control for each input channel. It determines the level of the signal sent from the corresponding input channel to the master stereo buss. The settings of the input channel faders determine the “mix” or balance of sound levels between the instruments or other sources connected to the inputs. I NPUT CH (-60~+4d8) LO-Z INPUT CH INSERT IN/OUT OdB ■ PHANTOM O 111 & tHOJCO UJ H- XXX UJ CO 0=5=3 3 _i or <<< a PAD 20dB GA I N CH -o
Strumenti Musicali - MC1603 (2.86 mb)
Strumenti Musicali - MC2403 (2.86 mb)
Strumenti Musicali - MC803 (2.86 mb)