Feel free to browse our product range to see what’s bubbling away at the moment or to ask for help on our products and services General Domestic Appliances Ltd. Morley Way Peterborough PE2 9JB Creda Answer Centre 08701 54 64 74 Web It may be necessary from time to time to change the specification outlined in this booklet without notice. Any change which is made will not affect your statutory rights. Contents Introduction Installation For your Safety – Always For your Safety – Never Features Cont

Always position the utensil on the burner grate before lighting the burner. For your safety, the flame should not extend beyond the sides of the pan. Any flame larger than the bottom of the cookware is wasted and only heats the handle. • To turn the burner off, turn the knob clockwise until it reaches the (•) symbol. • Before lighting a burner. Make sure all grates on the range are in place before using any burner. • After the burner ignites, turn the knob to adjust the flame size. Watch the

In order to choose the required orifice for particular burner and gas type; see the mark located on orifices and look at the information card. • Screw each orifice to proper matching burner. • Place the burner rings to their original locations. Be careful that the burner rings are level with the surface of the main top. • Keep the remaining orifices in their plastic bag for future use. (See Figure 16 and Table 1) BURNERS ! LP GAS NATURAL GAS RAPID ¡ 0.92 1.40 SEMI-RAPID 1 0.65 0.97 SIMMER

The inlet pressure of the gas supply shall be in accordance with the nominal inlet pressure of the regulator used on the range or 1/2 psi {3.5 kPa) pressure maximum. On the factory setting for Natural Gas operation, the pressure regulator will regulate the pressure to 6 inches water column pressure. When set for LP-Propane gas operation, it will regulate the pressure to 10 inches water column pressure. To change the pressure regulator setting: • Unplug the main supply cord of the range. • Un

If for some reason you are not happy with the service you receive, here are some steps to follow for further assistance. FIRST, contact the people who serviced your Gas Range. Explain why you are not pleased. In most cases, this will solve the problem. NEXT, if you are still not pleased, write all the details, including your telephone number, and send it to: Customer Service Avanti Products 10880 NW 30 Street Miami, FL 33172 PARTS & FEATURES 1 Cooktop 2 Control Panel 3 Oven Door Handle 4 Oven Do

IMPORTANT SAFEGUIDES Before the appliance is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the appliance, follow basic precaution, including the following: • It is recommended that a separate circuit, serving only your appliance be provided. Use receptacles that cannot be turned off by a switch or pull chain. • Never clean appliance parts with flammable fluids. These

Pull the ring over the claw-like hook, which is part of the hinge mechanism. Do not forget to do this on both hinges before the next step. (See Figure 10) • Raise the door slightly and pull it straight out and away from the oven. The door will come" completely off. • When replacing the door, locate it back into the hinge holes. Pull it down fully and slip the rings off the claw-like hooks. Figure 10 Close the door and make sure that it sits in place fully. If not, repeat all above steps. >

. GAS VALVES In the event of operating faults in the gas valves, call the Service Department. NOTE: Oven bulb replacement is not covered by your guarantee. Do not use steam jet cleaners because the humidity could infiltrate into the appliance making it dangerous. . BURNERS AND GRIDS . These parts can be removed and cleaned with appropriate products. . After cleaning, the burners and their flame distributors must be well dried and correctly replaced. . It is very important to check that the burne