valutazioni - 2, GPA: 4.5
(
)
)
|
Facilità d'uso
This ice maker is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet. Please read and follow the safety information listed below to reduce the risk of fire, electric shock or injury. Installation should only be done by a licensed plumber. Electrical Safety . Do not exceed the power outlet ratings. . It is recommended the ice maker be connected on its own circuit. . The unit must be installed in accordance with state and local electrical, water and drain codes. . A standard electrical supply (115 V, 60Hz), that is properly grounded in accordance with the National Electrical Code and local codes and ordinances is required. . Use outlets that cannot be turned off by a switch or pull chain. . Always turn the unit off and unplug it from the outlet when cleaning. . Unplug the unit if it is not going to be used for an extended period of time. . Do not operate the unit with a power plug missing the ground plug, a damaged cord or a loose socket. . Be sure the ice maker is properly grounded. . Never plug or unplug the unit with wet hands. . Do not bypass, cut or remove the grounding plug. . Do not use extension cords or power strips with this unit. You may need to contact your electrician if it is necessary to use a longer cord or if you do not have a grounded outlet. Do not modify the power cord’s length or share the outlet with other appliances. . Do not start or stop the unit by switching the circuit’s power on and off. . If the power cord is damaged, it must be replaced by the manufacturer or a qualified technician. . Never open the unit while it is plugged in. . Immediately unplug the unit if it makes strange sounds, emits smells or smoke comes out of it, and contact customer service. . Do not remove any part of the casing unless instructed by an authorized technician. . You should never attempt to repair the unit yourself. . Contact a customer service for service options if the unit needs service. General Safety . To prevent back and other types of injuries, use at least two people to move and install the ice maker. . Install the ice maker in a well ventilated area where the ambient temperature is above 50°F and below 100°F. . This unit is designed to be installed indoors, and protected from rain, sleet, snow, etc. . This unit is not intended to be used by children. . Children should be supervised to ensure that they do not play with this product. . Never allow children to crawl inside the ice maker. . Do not use this appliance near flammable gas or combustibles, such as gasoline, benzene, thinner, etc. . Do not place the unit near heat sources such as ovens, and grills. . Only use in an upright position on a flat, level surface and provide proper ventilation. . Do not pinch or kink the water or power supply lines between the unit and cabinet. . Unit installation must be in accordance with local plumbing code requirements. . Make sure that the water supply lines and pipes are not pinched or kinked. . Check for leaks after installation. . Discard the first batch of cubes produced by the ice maker. . Never turn the water supply tap off while the ice maker is running. . If the unit has not been used for an extended period, thoroughly clean it before using it. . Do not leave any cleaning solutions in the unit . Do not use solvent-based cleaning agents or abrasive solutions on the interior as they may transmit taste to the ice cubes and damage the interior. . Only connect a potable water supply. . This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, unless they have been given supervision or instruction concerning the use of the appliance by the person(s) responsible for their safety. KoldFront Built-in Ice Maker ii Table of Contents IMPORTANT SAFETY INFORMATION ................................................................. I INTRODUCTION ................................................................................................... 1 PARTS IDENTIFICATION ..................................................................................... 2 BACK VIEW .......................................................................................................... 2 FRONT VIEW ........................................................................................................ 2 INSTALLING THE ICE MAKER ............................................................................ 3 TYPES OF INSTALLATION....................................................................................... 3 Free-standing installation: ............................................................................. 3 Recessed installation: ...........................................................