3. Turn on the main water supply and tap. Check for water supply connection leaks. Tighten any connections (including connections at the valve) or nuts that leak. 4. Pour 1 gallon of water into the ice storage bin to check for leaks at all drain connections and the nut of the drain water hole. Tighten any connections or nuts that leak. (This procedure will also indicate if the drainpipe is kinked or pinched.) 13 5. If the electrical outlet for the ice maker is behind the cabinet, plug in the ice

4. Locate the condenser surface. Condenser surface 5. Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner. 6. Reassemble the front cover. 7. Plug in the ice maker or reconnect power. DO NOT touch condenser fins. They are sharp and can be damaged easily. 19 Interior Cleaning The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for the first time and reused after stopping for an extended perio

5. Push the ice maker into position. 6. Seal all around the cabinet to the floor with an approved caulking compound. Operation Final Check List before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the ice maker? 2. Did you clean the ice storage bin? (See pages 15 - 17.) 3. Have the installation instructions been followed, including connecting the machine to water and electricity? 4. Has the machine been leveled? 5. Is the ice cube machine in a si

Este seguro que la maquina este parada en posicion vertical 24 horas antes que sea conectada. Soyez surs que la machine se tient debout 24 heures avant qu’elle se branche. Models/Modelos/Modeles : FIM70, FIM90, FIM120 TABLE OF CONTENTS Page ICE MAKER SAFETY ······························2 IMPORTANT SAFEGUARDS··························3 - 5 TECHNICAL INFORMATION··························5 INTRODUCTION·································6 COMPONENT LOCATIONS···························7 ICE MAKER INST