thickness of mounting surface 1 3/16“ Max. flow rate 2.2 gpm Operating pressure: max. 147 psi Recommended operating press.: 14.7 - 72.5 psi Test pressure: 232 psi Hot water temperature: max. 176° F* Recommended hot water temp.: 120°F - 140°F* *Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no higher than 112oF. Installation Considerations Hansgrohe recommends that this faucet be installed

Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’s instructions when using. • Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause considerable damage to finishes and to plastic components. • Never mix cleaning materials. • Never use cleaners containing abrasives.

Installation Flush the supplies thoroughly before installation. Install the metal washer and friction washer on the valve. Push the valve up through the hole in the mounting surface. Install the mounting plate. Rest the valve assembly on the mounting surface. Tighten the screws. Place the handle assembly over the valve with the lever or cross in the desired off position. Hold the lever or cross steady with one hand. With the other hand, thread the escutcheon down over the mounting plate. Assembl

Turn the handle back (counter-clockwise) to turn the cold water off. Turn the hot handle forward (counter-clockwise) to turn the hot water on. Turn the hot handle back (clockwise) to turn the hot water off. Technical Data Recommended hole size spout 1 3/8“ valves 1 1/4“ Maximum depth of mounting surface 1 1/8“ Flow rate @ 45 psi 2.2 gpm Maximum water pressure 145 psi Recommended water pressure: 14.5 - 75 psi Recommended hot water temp.: 120oF - 140oF* *Some municipalities limit the maximum water

Please know and follow all applicable local codes when setting the temperature on the water heater. Prepare to install the faucet: Prior to installation, install the supply stops. Hot and cold supply lines and nuts are not included with the faucet. They must be purchased separately by the plumber or by the consumer. Flush the supply lines thoroughly. Damage to the faucet caused by debris in the water line is not covered under the limited lifetime warranty. • Install the valve bodies to the lavat

Please know and follow all applicable local codes when setting the temperature on the water heater. Minimum 1" air gap must be maintained between the spout outlet and flood level of the lavatory. Know and follow all applicable local codes regarding the air gap. AXOR’

Installation Consideration Rough-in 10303181 must be installed, and the wall finished, prior to installation of this trim kit. For the trim to fit properly, the outside surface of the finished wall must fall between the “minimum” and “maximum” lines on the factory installed plaster shields on the rough-in. If the rough-in is too far inside the wall, install extension kit 96259000 (purchased separately) before attempting to install the handle trim. No drain is included with this trim kit. Please

Turn the hot handle forward (counter-clockwise) to turn the hot water on. Turn the hot handle back (clockwise) to turn the hot water off. Technical Data Recommended hole size spout 1 3/8“ valves 1 1/4“ Maximum depth of mounting surface 1 1/8“ Flow rate @ 45 psi 2.2 gpm Maximum water pressure 145 psi Recommended water pressure: 14.5 - 75 psi Recommended hot water temp.: 120oF - 140oF* *Some municipalities limit the maximum water temperature from the water heater to 120o or below. Please know and