valutazioni - 2, GPA: 3
(
)
)
|
Facilità d'uso
Zune Playing and charging your Zune a) Place proper insert for your Zune (see insert table under Quick Start) in Dock (slide the Zune connector to left or right to match the proper insert if needed), then gently dock Zune. When docked, your Zune will charge until fully charged. Unit will not overchargeZune. b) Press the Button to play Zune, and again to pause. c) Turn the Volume Wheel to adjust ZN90 volume up or down. d) Press the EQ Button to select Treble, Bass, 3D sound effect or Balance. Turn the Set Wheel to adjust settings. EQ settings for Zune and radio mode are independent. e) Press the Button to turn ZN90 off and pause the Zune. Note: If you dock a Zune with a drained battery, it may take up to few minutes of charging before the Zune will respond. 3 Using the ZN90 Radio Setting up Antennas a) Snap AM loop antenna into provided stand, then plug AM antenna cable into AM Loop Antenna socket on back of unit. Move antenna 12” away from unit for best reception. b) Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas. c) Locate ZN90 and all antennas away from AC adaptor in wall socket (at least 3 feet) for best radio reception. Tuning and Playing the Radio a) Press the Radio/Line in Button to select radio play mode. Press as needed to select FM or AM radio band. b) Turn the Set Wheel to tune radio to a desired station. c) To program the current station as a preset, press and hold Preset Button 1-2 until P1 flashes on display; press again for P2 and allow to time-out (beep confirmation). Repeat steps a,b,and c for other preset buttons to preset up to 12 stations (6 AM, 6 FM). To listen to a preset station at any time, simply press the desired preset button once or twice. d) Turn the Volume Wheel to adjust ZN90 volume up or down. e) Press the EQ Button to select Treble, Bass, 3D sound effect or Balance. Turn the Set Wheel to adjust settings. EQ settings for Zune and radio mode are independent. f) Press the Button to turn ZN90 off. Using the Line-in and Line-out Jacks a) Use an audio patch cord (available at to play nondocking Zune or other audio devices through the ZN90 Line-in Jack (connect one end in the device’s line out or headphones jack, the other in the ZN90 line-in jack). Make sure thereis no Zune docked in the ZN90 when using the line-in jack. b) To listen to your audio device, press the Radio/Line in Button until line-in is displayed, indicating line-in mode. Adjust the output volume on your line-in device. c) Use the Line Out Jack to connect the ZN90 to the line-in jack of other audio devices such as a tape recorder or amplifier. The Volume Wheel of the ZN90 does not control line-out volume (adjust on attached device instead). The Line Out Jack is not for headphones. Using Sleep Mode Sleep mode lets you sleep to your Zune or the radio, gradually lowering the volume until the unit shuts off at the selected time. a) Press the Sleep Button to select an amount of time before the ZN90 shuts off: 120, 90, 60, 30 or 15 minutes. b) Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting). Using the Dimmer a) Press the Snooze/Dimmer Button during normal operation to adjust brightness of LCD display. There are 8 levels of brightness including OFF. Install/Replace Backup BatteryThe ZN90 uses a backup battery system to provide continuous alarm operation and clock settings in the eventof a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace thebackup batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement. Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries as indicated. We recommend the use of alkaline batteries for longer life. Replacing ZN90 Backup Batteries Battery Warning For models that require more than one battery • Do not mix with used or other battery types/brands • Do not heat above 75.C (167.F) • Replace all batteries at the same time • Do not expose contents to water • Do not open batteries • Do not charge or recharge • Do not dispose of in fire • Do not install backwards 4 A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. Fo...
Questo manuale è adatto anche per i modelli :ricevitori radio - IHOME ZN90 (353.2 kb)