|
Facilità d'uso
4. Depress the time type setting lever (Figure 2, Number 4). Using a small screwdriver or similar tool, rotate each individual date and time type wheel down to the correct date and time. (Note: Month and date type wheels must be reset manually the first day of each month.) 5. Depress the number type setting lever (Figure 2, Number 5) and rotate the number type wheels (Figure 2, Number 6) to the correct position. 6. Close the top frame and insert the locking pin, positioning the pull ring down and inside the case. Reinstall the top cover, fitting the top securely into the grooves in the main frame case. Lock the top in place. 7. Connect the power source. 8. Make a registration to check for accurate date, time, and number readings. If necessary, reset the digital display. (See Page 7.) Figure 2 7 -LT Series Operations Manual SETTING THE DIGITAL DISPLAY Models with a "C" affixed to their designation (LTTC and LTTNC) denote units featuring a digital display. This display is factory-set for use in the 12-hour AM/PM format or the 24-hour (Continental) format. The digital display should always be synchronized with the time type wheels. To set the digital display and synchronize the display with the time type wheels, do the following: 1. Connect the power source. 2. Locate the three (3) push-buttons labeled SEC, HRS and MIN on the bottom of unit (Figure 3). Figure 3 3. Return the unit to its upright position with the digital display facing towards you. Pull the unit forward slightly so the front hangs over the edge of the table, thereby giving you access to the buttons. (Remember: The minute button is on the right.) 4. Make a registration to see what time is indicated by the time stamp. Use the HRS (center) and MIN (right) buttons to set the time to the hour and minute indicated on the registration. 5. Place your finger on the minute button (right) but do not press it just yet. Listen for the type section to advance; you will hear an audible click. When you hear the click, immediately press the minute button to advance one minute. Seconds are now synchronized with the type section. 6. Make another registration to check the imprint feature for accuracy. (Note: Interruptions in power lasting more than 3 to 5 seconds will cause the digital display to flash, indicating that it is necessary to reset the display.) 8 - LT Series Operations Manual ADJUSTING PRINT IMPACT Print impact may be set to any desired level, from very hard to very light. The impact adjuster is located on the bottom of the unit. Using a small flat head screwdriver, turn the adjuster to the right to increase or left to decrease the impact. (Figure 4) (Note: To extend the effective life-span of the unit, use the lightest adjustment possible, which still gives a legible imprint.) Figure 4 REPEAT/ADVANCE OPERATION The Repeat/Advance switch (Figure 5), located on the back of the machine, allows you to control the numbering feature of the unit. The Repeat/Advance switch provides the option of numbering items ...
Questo manuale è adatto anche per i modelli :Registratori di tempo - LT Series (3.9 mb)
Registratori di tempo - LTD (3.9 mb)
Registratori di tempo - LTN (3.9 mb)
Registratori di tempo - LTTC (3.9 mb)