valutazioni - 1, GPA: 3
(
)
)
|
Facilità d'uso
To utilize these options: • To REPEAT an imprint with the same number, flip the switch to the UP position. • To ADVANCE the numbering wheels, press and hold the switch and press the Manual Registration Button to advance one number at a time. Continue pressing until the desired number is reached. • Return the switch to the CENTER position for normal operations. Figure 5 9 - LT Series Operations Manual CONSECUTIVE/DUPLICATE COUNT (Numbering Units) Units equipped with the numbering feature may be configured for Consecutive Count, advancing the number type wheel after each registration, Duplicate Count, advancing the number type wheel after every two registrations., Triplicate Count, advancing the number type wheel after every three registrations, or Quad Count, advancing the number type wheel after every four registrations. All units are shipped with the Consecutive Count mode enabled. Units having circuit board version “E” and above also support Triplicate and Quad numbering options. (See figure 6b). To switch to Duplicate Count mode, disconnect the power. Locate and remove the Access Cover (Figure 4) using a Phillips-head screwdriver. The version of the Control Circuit installed is indicated on the product label, on the underside of the unit, as well as on the circuit board, itself. On version “D” circuit boards, the shunt is placed over 2 pins (Figure 6a). Remove the shunt and place it over just 1 pin. To return to the Consecutive mode, reverse the procedure. For units having circuit board version “E” and above, the DUP, TRIP, and QUAD numbering features are selected by positioning the shunt according to (Figure 6b). Figure 6a Figure 6b 10 -LT Series Operations Manual ADJUSTING THE REGISTRATION POSITION Depending on the type of document being stamped, it may be necessary to change the registration position. This can be accomplished by moving the trigger assembly. The trigger assembly has a range of motion of about two (2) inches forward or backward. The trigger assembly tells the unit how far the document must be inserted before activating the stamp. The print locators on either side of the top cover (Page 5, Figure 1, Number 1) can help you center the registration point. To adjust the registration position: 1. Disconnect the power source. 2. Remove top cover and frame locking pin as described on Page 6. Lift the top frame. 3. Loosen the trigger adjustment screw (Figure 7, Number 1) and slide the trigger assembly (Figure 7, Number 2) to the desired position. (Note: Moving the trigger assembly towards you places the registration closer to the edge of the document. Moving the trigger assembly away from you places the registration farther from the edge of the document.) Figure 7 4. With trigger assembly in the desired position, tighten the trigger adjustment screw. 5. Close the top frame, install the frame locking pin, and replace the top cover. 6. Connect the power source. 7. Make a sample registration. If the registration is not in the desired location, readjus...
Questo manuale è adatto anche per i modelli :Registratori di tempo - LT Series (3.9 mb)
Registratori di tempo - LTD (3.9 mb)
Registratori di tempo - LTN (3.9 mb)
Registratori di tempo - LTT (3.9 mb)