valutazioni - 4, GPA: 3.8 ( )

Produttore : Bradley Smoker File Size : 227.87 kb File Nome : fa1559.pdf Lingua di insegnamento:

Do not use pipe dope on faucet and supply connections. Possible solenoid contamination could occur and will void any warranty. Teflon tape is the recommended sealant. Use plumber’s putty only to seal the faucet to the deck. The installation site should have access to an electrical box with 120 volt AC, 60 Hz cycle for input to a transformer. When installing the transformer, the electrical box should be located within six feet of the sink. The DC faucets are powered by four “AA” factory-installed alkaline batteries. Product warranties may be found under “Product Information” on our web site at Compliance and conformity to local codes and ordinances is the responsibility of the installer. 215-1559 Rev. A; EN 04-216A P.O. Box 309, Menomonee Falls, WI 53052-0309 © 2004 Bradley Corporation Phone: 1-800-BRADLEY FAX: (262) 251-5817 Page 1 of 8 9/23/04 Aerada 1000 Series Gooseneck Faucet Table of Contents Faucet Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Supplies Required for Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Installation Information Installing Single Hole and Cover Plate . . . . . . . . . . . . . . . . . . . . . . . .3 Installing Solenoid Valves and Electronic Box (AC) . . . . . . . . . . . . . .4 Installing Electronic Battery Box (DC) . . . . . . . . . . . . . . . . . . . . . . . .5 Maintenance Information Changing Faucet Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Faucet Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7–8 Installation Instructions Components for Aerada 1000 Series Faucet Carefully separate all parts from packaging and check each part with the illustrations below. Make sure all parts are accounted for before discarding any packaging material. If any parts are missing, do not attempt to install your Bradley Faucet until you obtain the missing parts. 1000 Series Faucet (shown w/cover plate) Electronic Box and Solenoid Spout Vandal-Resistant Aerator (269-1817) Spout Nut Spout Shank Sensor Collar 4" Cover Plate (optional) Collar Gasket Screw Stilt Washer Shank Washer Locking Nut Baseplate Partition Assembly Electronics Cover Screw Screw Screw Foam Gasket Collar & GasketOuter Strain Relief Bracket Solenoid DIN Connector Cable (Collar Assembly) Cable (Solenoid Assembly) 269-1809-AC (shown), 269-1810-DC (w/Batteries) 269-1813 269-1808 Supplies Required for Installation: • Teflon Tape • Plumber’s Putty (for securing faucet to deck ONLY) • 1/2" NPT water inlet supply • Pipe fittings 9/23/04 Bradley Corporation •215-1559 Rev. A; EN 04-216A Installation Instructions Aerada 1000 Series Gooseneck Faucet Installation Instructions - Single Hole and Cover Plate Remove the locknut (1), washer (2), stilt washer (3) from the spout shank (4). Remove shank from cover plate (if supplied). Install stilt washer (1) all the way up onto shank, crown side up. Position sensor cable (2) through one of the rounded slots in the stilt washer (1). 1 2 5 If faucet was installed with cover plate, secure cover plate with basin washers (1), flat washers (2) and locknuts (3). 1 2 3 CAUTION: Flush water lines 7a before beginning this step. Attach the outlet assembly (1) and aerator gasket (2) to the spout. The outlet assembly is equipped from the factory with a 0.5 GPM cartridge (white screen). To configure the 2 outlet with the 2.2 GPM cartridge (yellow screen) refer to...

Scarica la tua

Per scaricare, digitare 2 cifre :