|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
18 0/4/2/0.e.0
SCSI HP DG146BB976 SAS 146 GB HP66
Continue ([y]/n)?
19 0/7/0/0/0/0
LPe11002 PCIe 4Gb/s 2.5Gb/s, x4 Port 1 Fibre N/A
20 0/7/0/0/0/1
LPe11002 PCIe 4Gb/s 2.5Gb/s, x4 Port 2 Fibre N/A
Legend:
Indx = Index number used for referencing the device
Rev = Firmware Revision of the device
Note: Due to different calculation methods used, the size
of the device shown is only a rough approximation.
Create a firmware file list? (q for quit) [default for y]
Please wait while I search for all the firmware files.
Note: This may take a while if you are booting from tape.
.....
***************************************************************************
* Firmware Files Found (not disks) *
***************************************************************************
File name Intended Product ID Rev. Size
----------------------------- -------------------------------- ------ --------
msa60_212.frm HPMSA60 disk drive 2.12 3 1310738
Legend:
File name = name of the firmware file
Intended Product ID = firmware file's intended product name
Rev. = firmware Revision of the firmware file
Size = exact byte size of the firmware image
DFDUTIL>
1
Entry for an MSA60
2
The firmware version
3
The firmware version
enclosure.
that is currently
contained in the
installed on the
downloaded firmware
MSA60.
file.
4.
Verify that the MSA device and the firmware file are listed.
•
If the MSA device is not listed, check all cable connections and reboot the server to the
EFI shell.
•
If the firmware file is not listed, repeat the steps in “Downloading the Enclosure
Firmware File” (page 3); then repeat the steps in “Determining the Current Enclosure
Firmware and Verifying the Firmware File” (page 3).
Updating the Enclosure Firmware
NOTE:
The following is a generic procedure to update firmware from the EFI shell. HP
recommends that you follow the procedures supplied with the update package to install the
firmware update.
Use DFDUTIL from the EFI Shell to update the firmware image on the enclosure.
To update the enclosure firmware with DFDUTIL, follow these steps:
1.
If you have not already done so, perform the steps in “Downloading the Enclosure Firmware
File” (page 3), “Preparing to Run DFDUTIL” (page 3), and “Determining the Current
Enclosure Firmware and Verifying the Firmware File” (page 3).
2.
To update the firmware on the enclosure, enter the update
of the image file that you downloaded. Follow the prompts until the update completes. For
example:
DFDUTIL> update msa60_212.frm
Do you want to skip devices that are already at rev 2.12? ([y]/n) n
About to work on (8) range of disks w/MSA60_212.FRM firmware file.
**************************************************************
Updating Enclosure Firmware Offline
5
... Questo manuale è adatto anche per i modelli :
Apparecchiature di rete - HP-UX 11i v2 I/O Cards (275.53 kb)
Apparecchiature di rete - HP-UX 11i v3 I/O Cards (275.53 kb)