Do not remove the disc flange. OPERATION • Make sure the flats on the bottom of the disc flange are engaged with the flats on the spindle. • Place the grinding wheel over the spindle. • Thread the clamp nut on the spindle with the flat side of the nut facing up. • Fit the raised, small diameter portion of the clamp nut into the hole in the wheel and finger tighten. WARNING: Always install a grinding wheel with the depressed center against the disc flange. Failure to do so will cause the grinding

1 ASSEMBLY WARNING: The angle grinder should never be connected to a power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when the tool is not in use. Disconnecting the tool will prevent accidental starting that could cause serious injury. Attaching the Side Handle See Figure 2. Follow these steps to attach the side handle. ¦ Unplug the grinder. ¦ Screw the handle into the side of the gear housing. Note: You can install the handle on either the lef

CAUTION: (Without Safety Alert Symbol) Indicates a situation that may result in property damage. SERVICE Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we suggest you return the product to your nearest AUTHORIZED SERVICE CENTER for repair. When servicing, use only identical replacement parts. WARNING: To avoid serious personal injury, do not attempt to use this product until you read thoroughly and understand completely t