valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
-Never reach into the feeding tube with your fingers or an object while the appliance is running. Only use the pusher for this purpose. -Do not touch the small cutting blades in the base of the filter. They are ver y sharp. caution -Only connect the appliance to an ear thed wall socket. -This appliance is intended for household use only. -Never use any accessories or par ts from other manufacturers or that Philips does not specifically recommend. If you use such accessories or par ts, your guarantee becomes invalid. -Make sure all par ts are correctly mounted before you switch on the appliance. -Only use the appliance when the locking arm is in locked position. -Only unlock the locking arm after you have switched off the appliance and the filter has stopped rotating. -Do not remove the pulp container when the appliance is operating. -Always unplug the appliance after use. -Noise level: Lc = 75 dB(A) Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Preparing for use Wash all detachable parts (see chapter ‘Cleaning’). Unwind the cord from the bottom of the appliance (Fig. 2). Place the juice collector on the motor unit (1).To place the pulp container, tilt it forwards slightly (2). Insert the top end of the pulp container first and then push home the bottom end (Fig. 3). 1 2 3 To empty the pulp container while you are juicing, switch off the appliance and carefully remove the pulp container. Note: Reassemble the empty pulp container before you continue juicing. 4 Put the filter in the juice collector (1). Hold the lid over the filter and lower it into position (2) (Fig. 4). Make sure the filter is fitted securely onto the driving shaft (‘click’). Always check the filter before use. If you detect any cracks or damage, do not use the appliance. Contact the nearest Philips service centre or take the appliance to your dealer. 5 Lift the locking arm to locked position (‘click’). Align the groove in the pusher with the small protrusion on the inside of the feeding tube and slide the pusher into the feeding tube (Fig. 5). Make sure the locking arm is in the locked position. EnglisH 7 6 Put the lid on the juice jug to avoid splattering. Place the juice jug under the spout (Fig. 6). 7 Push the spout downwards before you start juicing. Note:When the spout is in upward position, it functions as a drip stop when the appliance is switched off. However, if you leave the spout in upward position during juicing, juice splashes out the spout. using the appliance The appliance only functions if all par ts are assembled properly and the lid is properly locked in place with the locking arm. 1 2 Wash the fruit and/or vegetables and if necessary cut them into pieces that fit into the feeding tube. (Fig. 7) Slide the foam separator into the juice jug (1) and place the lid on the juice jug (2). In this way, the foam stays behind in the jug when you pour out the juice. (Fig. 8) Note: If you want your drink to have a foamy layer, do not use the foam separator. Note: If you want to store the juice in the refrigerator, make sure the lid is on the juice jug. 3 4 Make sure the juice jug is placed under the spout and the spout is in downward position. Turn the control switch to setting 1 (low speed ) or 2 (high speed) to switch on the appliance. (Fig. 9) -Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes, tomatoes, cucumbers and raspberries. -Speed 2 is suitable for all other kinds of fruits and vegetables. 5 Put the pieces of fruit or vegetables in the feeding tube and gently press them down towards the rotating filter with the pusher (Fig. 10). Do not exer t too much pressure on the pusher, as this could affect the amount of juice output. Tip:The slower you press, the more juice output you get. 8 EnglisH Never insert your fingers or an object into the feeding tube. After you have processed all ingredients and the juice flow has stopped, switch off the appliance and wait until the filter has stopped rotating. 6 Push the spout upwards to prevent juice from dripping out of the spout. tips -Use fresh fruit and vegetables, as they contain more juice. Pineapples, beetroots, celer y stalks, apples, cucumbers, carrots, spinach, melons, tomatoes, pomegranates and grapes are par ticularly suitable for processing in the juicer. -You do not have to remove thin peels or skins. Only remove peels which you would not eat, e.g. those of oranges, pineapples, kiwis, melons and uncooked beetroots. -When you prepare apple juice, remember that the thickness of the apple juice depends on the kind of apple you use.The juicier the apple, the thinner the juice. Choose a kind of apple that produces the type of juice you prefer. -Apple juice turns brown ver y quickly.To slow down this process, add a few drops...