valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
Prepare the library for use
1.
Detach the ESD strap and close the service access
door.
2.
Inside the module, replace any magazines that
fit in their previous locations.
3.
Put the drive online by using the Vary On
operation:
a.
From the LCM, select Tools→Drives.
b.
In the Drive(s) table, click to highlight the
drive to vary on.
c.
Click Vary On.
4.
Go to the rear of the module and observe the
1. Ethernet port
following:
2. FC port 1
•
The green LED is solid on for three seconds
3. FC port 2
then blinks twice and repeats while the drive
firmware is downloading. It can take up to
3.
If this is a new drive installation, connect the
20 minutes to complete the drive sled
Ethernet Crossover cable to the Ethernet port and
firmware download.
the other end to the appropriate EEB port as
•
The green LED blinks one time every second,
follows:
the amber LED is off, and the blue LED blinks
one time every 10 seconds when the drive
EEB
Port
Drive bay
Drive # (bottom to
sled firmware download is complete.
top)
•
After a few minutes, the green LED should
Bay 8
Eth 6
Upper drive bay 12
blink at the same cadence as the other drives
(upper)
Eth 5
11
in the module.
Eth 4
10
NOTE:
After you install a
Eth 3
9
replacement drive, the robotic control
unit (RCU) makes certain that the drive
Eth 2
8
sled is loaded with the proper
Eth 1
7
firmware. This firmware is based on
the currently installed level of library
Bay 7
Eth 6
Lower drive bay
6
firmware on the management control
(lower)
Eth 5
5
blade (MCB). If the autoleveling
process fails, the drive sled becomes
Eth 4
4
inoperable and the library reports this
Eth 3
3
by logging an event.
Eth 2
2
If additional drives have been added:
Eth 1
1
a.
From the library Operator Control Panel
(OCP), log in as either the service user (for
IMPORTANT:
Drives must be populated
HP personnel) or the admin user (for
from bottom to top, consecutively. Do not
customers replacing a drive without HP
install drives in the upper drive bay before
assistance).
the lower drive bay is full. Do not connect
b.
Select Tools→Library
cables to the upper EEB before the ports
Diagnostics→Teach→Configure→Start, and
on the lower EEB are connected.
allow the Teach operation to complete.
c.
Select a partition and add the new drive(s).
Page 5
... Questo manuale è adatto anche per i modelli :
dati dispositivi di elaborazione - HP StoreEver ESL G3 300 slot Tape Library (519.18 kb)
dati dispositivi di elaborazione - HP StoreEver ESL G3 700 slot Tape Library (519.18 kb)
dati dispositivi di elaborazione - HP StoreEver ESL G3 1500 slot Tape Library (519.18 kb)
dati dispositivi di elaborazione - HP StoreEver ESL G3 3000 slot Tape Library (519.18 kb)