valutazioni - 3, GPA: 4.3 ( )

Produttore : Frigidaire File Size : 718.29 kb File Nome : Lingua di insegnamento:

IMPORTANT: If flame does not activate after POWER ON/OFF button is pressed, press DISPLAY ON/OFF button to activate the flame. If flame does not appear, repeat step 4. Operating Instructions Continued Infrared Ray Exit FLAME TEMP. CONTROL POWER ON/OFF ON/OFF ON/OFF HIGH HIGHER MED LOW LOWER Dimmer Brighter EMBERS/ LOGSET HEATERDISPLAY Indicator Light Figure 4 - Remote Control For Electric Fireplace Cleaning and Maintenance WARNING: Always disconnect power and allow the heater to cool before performing any cleaning, maintenance or relocation of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater. Turn off heater and circuit breaker to heater before performing any cleaning and/or maintenance. Allow heater to cool completely. Bulb Replacement WARNING: The halogen light bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the heater and removing the light bulbs to avoid accidental burns. There are a total of 5 ( halogen light bulbs (type GX6.35 rated 120 volts, 35 watts) in your unit. • 1 bulb provides illumination for the ember bed beneath the log set • 2 bulbs provide illumination for the flame generation assembly • 2 bulbs for replacement Most halogen light bulbs are rated to last approximately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice one or more of the following: • Flame is dim or dark in certain areas • Log set ember bed appears dim or dark in certain areas WARNING: Do not install replacement bulbs that exceed specified maximum watts. Your unit must be opened from the back in order to replace the flame generation bulbs. To replace the bulb under the ember bed you will open the unit in front. Replacing Log Set Ember Bed Bulb 1. Turn knob and open door of stove. 2. Push in and up on lower front panel. The panel slides into notches on front sides of stove as shown in Figure 5. 3. Remove two screws securing grate. Remove grate. 4. Hold log up away from bulb and carefully remove spring clip over bulb using needle nose pliers. Remove bulb. 5. With log being held up away from socket, insert new bulb and carefully replace spring clip using needle nose pliers. Replacing Flame Generation Bulbs 1. Unscrew 4 screws from louvered back panel (see Figure 6). Remove louvered back panel. Log Lower Front Panel Bulb in Socket with Spring Clip Grate Figure 5 - Ember Bed Bulb Location Back Control Panel Louvered Back Panel Lower Back Panel Figure 6 - Back of Stove 2. Locate flame generation cylindrical drum (see Figure 7). It is constructed of two removable halves; either of which can be removed from the unit. 3. Squeeze half of drum cylinder until it's top edge clears the top drum track (see Figure 8). Remove bottom edge of cylinder drum from bottom drum track. This will give you access to the light bulbs. Note: Do not exert excessive pressure on drum cylinder as this may cause damage....

Scarica la tua

Per scaricare, digitare 2 cifre :