valutazioni - 4, GPA: 4.3
(
)
)
|
Facilità d'uso
INSTALLATION INSTRUCTIONS CONTENTS Contents of packaging Equipment required Optional accessories 1 x canopy hood Electric drill Light bulb 104467 2 x chimney pieces Drill bits Chimney ext. (10’ ) SS 8 x angle brackets Spirit level Chimney ext. (10’ ) IR 1 x installation instructions Screwdriver Charcoal filter 103821 4 x filters ( part number 104660) Jig saw Recirculation kit 1744 Installation kit ( part number 104922) Ladder 4 x 12 x 40mm screw Tape measure 30 x 6 x . ” self tapping screw Duct tape (2 spare) Ducting All electrical work must be done in accordance with local and/or national electrical codes as applicable. For safety this product must be earthed. If you are unfamiliar with methods of installing electrical wiring, employ the services of a qualified electrician. Turn off power at service entrance before installing wiring or servicing this product. lbs PRE-INSTALLATION Thank you for purchasing a quality, stainless steel canopy hood. We have a high standard of quality control and each canopy hood is tested and approved before it leaves the factory. IMPORTANT • Always switch the power off prior to installation, servicing or cleaning the canopy hood. • Never use the canopy hood without the filters. • Stainless steel is very easily damaged during installation if abraded or knocked by tools. Protect the top of the canopy with cardboard or polystyrene during installation. • Please read the entire instructions before installing the canopy hood. • A power outlet should be within 750mm from the motor assembly and can be either on the wall, behind the chimney or in the ceiling. An extension lead may be necessary on some installations. • To comply to electrical safety regulations this canopy must be plugged into a socket near the appliance. The socket must be accessible and enable the end user to isolate the canopy from the power for the purpose of internal cleaning or maintenance. Ducting accessories are not supplied. All ducting must comply with local requirements and building codes. The canopy hood is heavy please ensure adequate care when installing the canopy hood to prevent personal injury. The canopy hood must be installed onto a solid wall or solid stud. Weight of product 43.2 kg. HEIGHT OF CANOPY HOOD • The canopy is designed for 2440mm high ceilings. • The chimney is telescopic and is designed for hood installations between 600 to 750mm above the cooking surface. • Ascertain the desired installation height of the canopy hood. • Any installation above 750mm will compromise the extraction performance. • The air outlet from the motor requires 150mm round ducting which requires 170mm diameter hole in the ceiling. A=600 min (electric cook top) A=650 min (gas cook top) CONTROL PANEL Delay switch: Canopy hood will remain on a low, mid or high speed for five minutes to clear away all residual cooking odours before switching off automatically. FILTER SURFACE HOB TOP A Designer Series Island Canopy 80327 EC120DXV1 (SS NZ/AUS) 80328 EC120DMV1 (IR NZ/AUS) 88388 EC120DXV1 ( EU) 88833 EC120DXV2 (UK) Please note product...
Questo manuale è adatto anche per i modelli :Fans - 88833 EC120DXV2 (187.59 kb)
Fans - 80328 EC120DMV1 (187.59 kb)
Fans - 88388 EC120DXV1 (187.59 kb)