valutazioni - 4, GPA: 4.5 ( )

Produttore : Fisher & Paykel File Size : 187.59 kb File Nome : Lingua di insegnamento:

a. When fitting to a 50mm truss drill a pilot hole through the ceiling and into the truss. b. If securing to any other ceiling type please use appropriate fasteners and follow their instructions of use carefully. 5. For the ducting mark out and cut a O170mm hole in the ceiling. 6. Fix the ceiling bracket to the ceiling using the screws supplied. 7. Using duct tape secure the ducting to the top of the motor housing. Solid ducting, galvanized or plastic is recommended. Use flexi ducting only in difficult installations and if used ensure that it is pulled tight. The smoother, straighter and shorter the ducting the quieter and more efficient the canopy hood will perform. Tape the power plug to the top of the ducting, this will enable easy access to the plug after installation. 8. Mount the first set of four angle brackets on the canopy. Use eight self tapping screws, one per side per corner. 9. Determine the installed height of the canopy and attach the second set of four angle brackets to the first to achieve this height. Secure with eight self tapping screws, one per side per corner. 10. Strip the plastic protective film off the two chimney pieces and place these over the corners. The lower chimney will rest on top of the canopy hood and the upper chimney will be extended and secured to the ceiling bracket. To ensure that the upper chimney does not slip inside the lower chimney, secure it so that the upper chimney is showing. Duct tape or placing two screws/nails through the upper chimney securing holes will do this. 11. Offer the canopy hood, angle brackets, chimneys and ducting up to the ceiling bracket and secure in place with eight screws provided, one per side per corner. The dimension between the filters and the cooking surface should be in line with those suggested in the ‘height of canopy hood’ section. An additional person will be required for this operation or a simple support frame manufactured to the correct dimensions will aid assembly of the Designer Island canopy hood. 12. Finish assembling the ducting ensuring the path is as short, straight and smooth as possible. 13. Connect to the power supply and switch on the power using switch/socket outside the canopy hood. 14. Slide the upper chimney piece up to the ceiling and secure in place with four screws supplied. INSTALLATION – RECIRCULATED For recirculation do not cut the 170mm hole into the ceiling and purchase the charcoal filters and recirculation kit 1744. The recirculation kit must be used to channel the air to the top of the flue. For other accessories parts and service please contact your local supplier or approved service agent. MAINTENANCE The manufacturer is not liable for any damage caused by not following these instructions. Particular care must be taken with the grease filters which must be periodically cleaned (at least every two months). Remove the grease filters and wash them either by hand in hot soapy water or in the dishwasher using mild detergent. Note: some discolouration of the frame may occur. Caution: Never use abrasive or oil based liquid cle...

Scarica la tua

Per scaricare, digitare 2 cifre :