valutazioni - 4, GPA: 4.3
(
)
)
|
Facilità d'uso
Replace the filter to return to normal operation. To change the filter and reset the filter run-time counter: 1. First, turn off and unplug the air purifier. 2. Next, remove the front grill. For Models 30400 and 30401, place your fingers in the recesses on either side of the top of the grill and pull firmly. For all other models, gently press the push tabs until the front grill slides pass them and is released. 3. Gently pull on the filter to remove it from the unit. While removing the filter, note the direction of the flaps that form the seal. The new filter will be installed with the same orientation. Once removed, the used filter can be discarded. 4. Remove the new filter from its wrapping and look at the orientation of the rubber seals on the sides of the filter. The loose end of the flap should be facing out as the filter is placed into the air purifier. Press the filter firmly into the air purifier. To avoid damaging the filter media, you should press on the frame of the filter only. 5. Reinstall the grill by first lining up the tabs on the bottom of the grill with the openings on the air purifier base and then pushing the top of the grill forward until it is closed. Continued 19 41451-01 41451-01_Rev 8-6-04.pmd 19 8/5/04, 5:05 PM Air Purifier Maintenance Fig. 28DISPLAY FILTER RST 6. Plug in the unit. NOTE: This unit will not operate un- less the grill is in the correct position. The display will read “door” if the grill is not attached properly. 7. To reset the filter counter, press the DISPLAY key until the filter counter is displayed. Then, hold the FILTER RESET key for 2 seconds. The filter counter will return to zero and resume counting. Obtaining Replacement Filters To obtain replacement filters for your air purifier, first determine your model number by looking at the information label on the back of the air purifier. The model number will be listed on the label. Then, call 1-800-4HUNTER for your nearest retailer or Hunter Customer Service at 1-800-313-3326 (CAN 1-888-855-8300) to order directly. To order online, visit our Website at To ensure that you obtain the correct filters, please find your model number below that specifies the correct replacement filters. Hunter Air Purifier Model No.: .......................... 30130 Pre-Filter Replacement Model No.: ................... 30901 HEPA Filter Replacement Model No.: .............. 30936 Hunter Air Purifier Model No.: .......................... 30170, 30175, 30185 Pre-Filter Replacement Model No.: ................... 30901 HEPA Filter Replacement Model No.: .............. 30938 Hunter Air Purifier Model No.: .......................... 30400, 30401 Pre-Filter Replacement Model No.: ................... 30901 HEPA Filter Replacement Model No.: .............. 30940 41451-01 20 41451-01_Rev 8-6-04.pmd 20 8/5/04, 5:05 PM Troubleshooting Problem Solutions 1. No Display • Confirm that the unit is plugged in. • Check the installation of the front grill. • Reset the air purifier. (See Resetting the Air Purifier on pg. 17.) 2. Display reads “door.” •The front grill is not attached properly. Remove grill from unit and re-attach. (See Initial Operation on pg. 6.) 3. Program number is flashing. • Unit is in temporary program override mode. Refer to Override of Auto Mode on pg. 10. 4. Programs are not running. • Confirm that the unit is in Auto Mode. The Auto indicator should be lit and a program number should be illuminated. (See Auto Mode on pg. 9.) •Review program settings to confirm program set points. (See Reviewing Programs on pg. 16 for additional information.) 5. Time is not correct • Check that the proper display is chosen. (See Display Modes on pg. 8). • Set the time. (See Setting the Day/Time on pg. 12.) 6. Keypad does not work or •Key pad has been locked to prevent accidental changes display reads “Lock.” to the programs. (See Keypad Lock on pg. 16 to unlock the key pad.) 7. Erratic Display or • Reset the air purifier. (See Resetting the Air Purifier Operation. on pg. 17.) 8. Filter and/or Pre-filter •The Filter and/or Pre-Filter Counters have reached the Indicator is Flashing. estimated usage times. Check and replace filters if needed. (Refer to Filter and Pre-Filter Counters on pg. 11.) 9. Unit has reduced air flow •The filter is clogged and should be changed. (Refer to or increased noise. Changing the Filter on pg. 19.) Technical Support If you have any additional questions or problems with your Hunter air purifier, please call 1888- 830-1326 from 8:00 am to 5:00 pm Central Time or contact us over the Internet at 21 41451-01 41451-01_Rev 8-6-04.pmd 21 8/5/04, 5:05 PM Warranty Hunter Fan Company QuietFlo® True HEPA Air Purifier 5 YEAR LIMITED WARRANTY The Hunter Fan Company makes the following limited warranty to the original residential user or consumer purchaser of the QuietFlo® True HEPA Air Purifier: If any part of your QuietFlo® True HEPA Air Purifier motor or control panel fails during the first five ...
Questo manuale è adatto anche per i modelli :Aria - 30130 (1.06 mb)
Aria - 30401 (1.06 mb)
Aria - 30170 (1.06 mb)
Aria - 30175 (1.06 mb)