valutazioni - 0, GPA: 0 ( )

Produttore : Bosch File Size : 735.49 kb File Nome : Lingua di insegnamento:

An acoustic signal is issued and the display goes out. Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine. • Clean the extractor hood with a hot soap solution or a mild window cleaner. • Do not scrape off dried-on dirt but wipe off with a damp cloth. • When clearing the grease filters, remove grease deposits from accessibile parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. • Note: do not use alcohol (spirit) on plastic surfances, as dull marks may appear. Caution! Ensure that kitchen is adequately ventilated. Avoid naked flames. Clean the operating buttons with a mild soapy solution and soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless Steel surfances: • Use a mild non abrasive stainless steel cleaner. • Clean the surface in the same direction a sit has been ground and polished. Aluminium and plastic surfaces: • Do not use dry cloths. • Use a mild window cleaning agent. • Do not use aggressive, acid or caustic cleaners. Observe the warranty regulations in the enclosed service booklet. Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is stil a risk of burns. 2. Follows the steps shown in the L Series for replacing the lamps. 3. Replace the damaged halogen light bulb wth a new one with same characteristics. 4. Plug the appliance into the mains or switch it on at the fuse box. Note: if the light does not function, check that the bulbs have been inserted correctly. If you encounter a problem If a or appears in the display: • See “Filters and Maintenance“ Section. If it is not possible to operate the extractor hood: • Disconnect the extractor hood from the mains electricity supply by pulling out the plug or switching it off at the main fuse box. Wait for approx. 1 Minute and then switch it on again. If the lights of the lamps is weak when the hood is in stand-by, then invert the plug (invert phase with neutral). If you have any questions or if a fault occurs, please call Customer Service. (see list of Customer Service representatives). When you call please quote the following: E-Nr. FD Enter the relevant numbers into the box above. The E-Nr. (Product no.) and FD (Production date) are shown on the nameplace which can be seen inside the extractor hood after the filter frame has been detached. The manufacturer of the extractor hood accepts no liability for complaints which can be attributed to the design and layout of the pipework. Avant de lire ce qui suit, veuillez deplier les volets illustres. Remarques importantes Les anciens appareils ne sont pas...

Scarica la tua

Per scaricare, digitare 2 cifre :