Log:
Scaricare : 0   File Size : 397 kb   Produttore : Zenoah  
Categoria : Benzo e seghe

Scaricare : 0   File Size : 1 mb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name

17. When cutting a limb that is under tension, be alert for spring- back so that you will not be struck when the tension in the wood fibers is released. 18. Never cut in high wind, bad weather, when visibility is poor or in very high or low temperatures. Always check the tree for dead branches which could fall during the felling operation. 19. Keep the handles dry, clean and free of oil or fuel mixture. G2000T GB-4 20. Operate the chain saw only in well ventilated areas. Never start or run the e

Scaricare : 663   File Size : 809 kb   Produttore : Zenoah  
Categoria : Benzo e seghe

Scaricare : 6   File Size : 254 kb   Produttore : Zenoah  
Categoria : Benzo e seghe

Scaricare : 12   File Size : 814 kb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name

Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, etc. described therein, it may not be covered by the warranty. ¦ SUPPLYING CHAIN OIL WARNING Running the equipment for long hours with its chain oil run out will accelerate the wear and tear of the chain and guide bar, possibly resulting further in a chain cut and even in a fatal accident

Scaricare : 2   File Size : 565 kb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name@name

Before each use, check that the net is attached in place and is free from any damage. WARNING IMPORTANT Maintenance .15 . • Note that using any spark plugs other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged. • To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench. IMPORTANT Disposal • When disposing your machine, fuel or oil for the machine, b

Scaricare : 1   File Size : 1 mb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name

Continuously push the priming bulb until fuel comes in the bulb. 3. Set the switch to “I” position. Safety lever Switch Throttle lever 4. Turn the choke knob to the closed position. 6. When engine has ignited, first push in the choke knob to the first-stage position and then pull the starter again to start the engine. 7. Allow the engine to warm up with the throttle lever pulled slightly. Keep clear of the saw chain as it will start rotating upon starting of engine. WARNING G B ¦ CHECKING OIL SU

Scaricare : 2   File Size : 1 mb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name

Continuous operation with the brake engaged will generate heat from the clutch and may cause trouble. • At machine inspection prior to each job, check the operating condition of the brake following the steps. •When the brake operates, don’t put hands near the yellow cone pops up. 1. Start the engine and grasp the handle securely with both hands. 2. Pulling the throttle lever to maintain the chain operation, push the brake lever (left-hand guard) down toward the front using the back of your left

Scaricare : 26   File Size : 968 kb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name

(1) (2) (3) (1) muffler guard (2) guide bar (3) saw chain G2500 / G2500 OPS WORKING WITH TREE SERVICE CHAIN-SAWS FROM A ROPE AND HARNESS This chapter sets out working practices to reduce the risk of injury from tree service chainsaws when working at height from a rope and harness. While it may form the basis of guidance and training literature, it should not be regarded as a substitute for formal training. General requirements working at height Operators of tree service chainsaws working at heig

Scaricare : 4   File Size : 968 kb   Produttore : Zenoah  
Categoria : Benzo e seghe
@name

5. Sprocket Check for cracks and for excessive wear interfering with the chain drive. If the wear is considerable, replace it with new one. Never fit a new chain on a worn sprocket, or a worn chain on a new sprocket. 6. Way of the cooling air WARNING • The engine metal parts can burn your skin. Never touch the cylinder, muffler or ignition plug etc. during operation or right after stopping the engine. • Before starting the engine, check around the muffler and take off sawdust. If you do not, it





categorie