3 Problem Solver ............................. 21,22 Product Registration ............................. 3 Safety Instructions ........................... /4-7 State of California Water Treatment Device Certificate ............ 26 Warranty .............................. BackCover Care and Cleaning Cleaning-Outside and Inside .................. 13 Light Bulb Replacement ....................... 1/4 Vacation ....................................... Read this manual carefully. It is intended to help y

IMPORTANT – Observe all governing codes and ordinances. Note to Installer – Be sure to leave these instructions with the Consumer. Note to Consumer – Keep these instructions with your Owner’s Manual for future reference. WARNING – This appliance must be properly grounded. See “Electrical Supply”, page 4. AVERTISSEMENT – Cet appareil doit etre correctement mis a la terre. Consulter <>, page 4. If you received a damaged wine chiller, wine reserve or beverage center, you sh

The tinted glass will make the stained wood appear darker. A true color match can be seen only when the door is opened. • Apply the stain and sealer according to the manufacturer’s instructions. To avoid unpleasant odor, keep the door open to ventilate and allow the stain/sealer to dry completely before using the product. STEP 1 REMOVE PACKAGING • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. • Remove stainless steel toekick tap

. . . . . . . . . . . . . . . . . .4, 5 A Quick Tour of Your Wine Vault . . . . . . . . . . . . . . . .6, 7 The Cellar Management System . . . . . . . . . . . . . . .8–11 Key Parts and Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9 Key Areas of the Cellar Management System . . . . . . . . . . .10 Tips for Stocking Your Cellar the First Time . . . . . . . . . . . . . .11 The Cooling System . . . . . . . . . . . . . . . . . . . . . . . . . .12–17 Lockable Entry Door

The cooler area will be in the middle section. The upper part of the cabinet is the warmest section. When the temperature is adjusted, allow 24 hours for the unit to stabilize. To set the control, turn it to the midpoint setting (approximately 45.F). Once the beverage center is loaded, allow at least 24 hours before making any adjustments to the initial setting. Interior light The interior light makes it easy to view your beverage labels and enhances the and switch display of your collection. Wh

The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening must include filler panels. Note: When installed, the door should project forward 1" of adjacent 24"-deep cabinets. Side-by-Side Installation For a complete refreshment center, install a Monogram Wine Reserve and Beverage Center together. • Products must operate from separate properly grounded receptacles. Door Swing Clearances All

Wall24" Cabinet14" Minimum110. Wall24" Cabinet 34-1/2" Min. 24" Min. 23-3/4" 34-1/2" (36"with top canopy) 23-3/4"1-1/2" Locate Outlet 9" Max. 10-1/2" 26-1/2" Including Handle 23-3/4" Min. Note: Handle andhandle standoffdepth is 2-3/4" All models are factory set for a 110° door swing. For a minimum 90° door swing: • Allow 5-1/4" min. clearance to wall on the hinge side. For a full 110° door swing: • Allow 15" min. clearance to wall on the hinge side. Note: If installing between frameless cabinets

Whether you chose it for its purity of design or the assiduous attention to detail, you’ll find that your Monogram wine chiller’s superior blend of form and function will delight you for years to come. The information on the following pages will help you operate and maintain your wine chiller properly. If you have any other questions—please call the GE Answer Center® (800.626.2000). Contents Appliance Registration .................3 Built-In Dimensions .....................7 Care and Cleaning ..

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Reversing the Door Swing Wine Chiller To reverse the door Parts included: 1. Top left case hinge 2. Bottom left case hinge 3. Left and right side decorative hinge cover 4. Decorative hinge screw hole cover 5. Torx® driver bit Tools required: 1. Phillips screwdriver 2. Electric drill To remove the door: 1. Flatten the shipping carton to use as a pad. 2. Remove the 2 screws and the to

Whether you chose it for its purity of design or the assiduous attention to detail, you will find that your Monogram wine chiller’s superior blend of form and function will delight you for years to come. The information on the following pages will help you operate and maintain your wine chiller properly. Contents Built-In Dimensions . . . . . . . . . . . . . . . .10 Care and Cleaning . . . . . . . . . . . . . . . .8, 9 Consumer Information . . . . . . . . . . . .2, 3 Controls and Features . . .